Turbulent flow in a conical diffuser: A review

This is a review of experimental studies of turbulent flow in a conical diffuser by eight Ph.D. students, eleven M.Sc. students, one M.Eng. student, and myself in the past 29 years. During this time, two conical diffusers were constructed: the first was of cast aluminum construction, and the second was of plastic fabrication. These two diffusers were basically the same in geometry except that the pipe section was constructed as an integral part of the plastic diffuser to avoid the lip at the junction of the inlet pipe and the diffuser. The conical diffuser had a total divergence angle of 8 degrees, an area ratio of 4:1, and an inlet diameter of 0.1016 m (4 in.). The flow at the inlet of the diffuser was usually fully developed pipe flow, but sometimes it was boundary layer grown on the pipe wall. Hot-wire and pulse-wire anemometry together with computer facilities were used to obtain the results of complex flow present in the conical diffuser. Mean velocity profiles were obtained throughout the diffuser, which in turn were used to obtain strain rates and their principal direction. Turbulence moments up to fourth order were measured. The results were used to assess momentum, turbulent kinetic energy, and shear stress equations. Other features such as instantaneous flow reversals in the wall region, relative strength of large eddies, extra strain rate, and the production of kinetic energy also were investigated to find the dynamical picture in the diffuser flow. (C) Elsevier Science Inc., 1996