Influence of coefficient of uniformity and base sand gradation on static liquefaction of loose sands with silt

被引:59
|
作者
Monkul, Mehmet Murat [1 ]
Etminan, Ehsan [2 ]
Senol, Aykut [3 ]
机构
[1] Yeditepe Univ, Dept Civil Engn, Room B-418,26 Agustos Yerlesimi, TR-34755 Istanbul, Turkey
[2] Yeditepe Univ, Dept Civil Engn, Soil Mech Lab, 26 Agustos Yerlesimi, TR-34755 Istanbul, Turkey
[3] Istanbul Tech Univ, Dept Civil Engn, TR-34469 Istanbul, Turkey
关键词
Static liquefaction; Grain size distribution; Coefficient of uniformity; Sand; Silt; Triaxial compression test; UNDRAINED SHEAR-STRENGTH; STRESS-STRAIN BEHAVIOR; NONPLASTIC FINES; DEPOSITIONAL METHOD; GRANULAR SOILS; RESISTANCE; MINIMUM; MAXIMUM; RATIO;
D O I
10.1016/j.soildyn.2016.08.001
中图分类号
P5 [地质学];
学科分类号
0709 ; 081803 ;
摘要
When occurred on site static or flow type liquefaction could result in catastrophic consequences due to its sudden occurrence with large strains. Presented here is an experimental study based on monotonic undrained triaxial compression tests conducted on three clean sands and their mixtures with three different non-plastic silts at three different fines contents ( <= 25%). The results demonstrate that base sand gradation has significant influence on the static liquefaction potential of clean and silty sands. It was observed that clean sands become more liquefiable as their mean grain size got smaller and/or they became more uniform. However, it was found that the order of liquefaction resistance of the same base sands were reversed when they were mixed with silt (i.e. resulting silty sands become more liquefiable as the mean grain size of base sand got larger and/or base sand became relatively well graded). Possible reason for such a reversed behavior was hypothesized and then experimentally justified with extra tests. It was also found that the influence of base sand gradation on static liquefaction of loose specimens was most significant at low fines content (e.g. 5%) and almost erased at relatively high fines contents (e.g. 25%). In the last part of the study, the relationship between the normalized peak deviator stress (q(peak)/ sigma'(3c)) and coefficient of uniformity (CU) is discussed. It was shown that unlike clean sands, for which liquefaction potential decreases with increasing CU, the liquefaction potential of sand-silt mixtures reconstituted in the laboratory increases with increasing coefficient of uniformity (i.e. technically as they became more well graded). Two equations were proposed to represent the discussed relationship between q(peak)/sigma'(3c) and CU; one for stable and temporarily liquefied specimens, the other for liquefied specimens. Finally, the applicability of these equations to other types of silty sands in literature was shown. (C) 2016 Elsevier Ltd. All rights reserved.
引用
收藏
页码:185 / 197
页数:13
相关论文
共 39 条