Catalytic wall reactor Catalytic coatings of stainless steel by VOx/TiO2 and CO/SiO2 catalysts

Catalytic wall (structured) reactors and structured supports are suitable to study the catalytic properties of nanosized materials. The coating of metallic (aluminum and stainless steel) plates by thin layers of active phase is presented in two cases, VOx/TiO2 and CO/SiO2, catalysts used in the oxidative dehydrogenation (ODH) of propane and in Fischer-Tropsch synthesis (FTS) of clean fuels, respectively. The preparation of coated plates and their characterisation by various methods of physicochemical analysis are described. Both chemical and physical methods were used for coating. VOx/TiO2 layers were obtained by grafting of Ti (on A] or stainless-steel plates) and V (on TiO2) alkoxides and use of sol-gel media or suspension. A silica primer was deposited (on stainless-steel plate) by plasma-assisted chemical vapour deposition (PACVD) onto which Co oxide and silica were coprecipitated from sol-gel. The catalytic experiments in the respective reactions were carried out in special plate reactors and compared with those of catalytic powders. The study shows that the coating of a metallic substrate by a catalyst is not straightforward and requires specific studies dealing with both chemistry (chemical affinity between substrate and catalytic layers) and catalytic engineering (catalytic performance in taylor-made reactors). (c) 2007 Elsevier B.V. All rights reserved.