Design and development of sensor based Automatic steering control system for automobiles

Drowsy driving is the major problem seen throughout the world which usually happens when the driver has not slept enough, and this state of mind may lead to accidents. Above being the case, the project helps driver to keep him alert by giving an alarm and to minimize accidents due to driver error, distractions and drowsiness. The research derives, implements, tunes and compares selected path tracking methods for controlling a car-like robot along a predetermined path. The model mainly aims on using active steering control to increase safety and to reduce both accidents and drivers work load. The objective of the project is to design and develop a steering control system for the path tracking of autonomous vehicle & to understand the stability of the vehicles on curved road. The steering controller controls the steering actuator to follow the desired steering angle. A servo motor is installed to control the steering handle, and it can transmit the steering force using a belt and pulley. The developed mechanism is a steering controller that is applied to a micro controller. However, because of a dead band, the path tracking performance and stability of autonomous vehicles are reduced. To overcome this, steering system and programme is developed. As a result of the steering system and programme, the performance and stability are improved. GPS shows the geographical coordinates which specifies any given location on the earth surface as latitude and longitude. Ultrasonic sensor used for detecting the obstacles. A magnetometer compass shows the quadrants. Arduino UNO board is used like a mother board in the project. Finally, the project augments the literature with a comprehensive collection of important path tracking ideas, a guide to their implementations and, most importantly, an independent and realistic comparison of the performance of these various approaches. (c) 2020 Elsevier Ltd. Selection and peer-review under responsibility of the scientific committee of the International Conference on Advances in Materials and Manufacturing Applications.