EXPERIMENTAL ANALYSIS OF 3D PRINTED PALLET MODEL THROUGH FUSED DEPOSITION MODELING

Disparate industry bodies across the planet use pallets for storing large and heavy objects. Pallets provide an assurance of safe handling of material (cargo) and storage of material in a damage-free environment. In this work, an attempt has been made to analyze and investigate making pallets out of ULTEM 9805 using the latest additive techniques (FDM). The maximum deflections and von Mises stresses are analyzed for the disparate boundary conditions indicating the possible alternatives or loads to be used. Study of surface (morphology) and characteristics was done in order to establish the relationship between pallet surface and its application. The factors of load, maximum and minimum values, ascertained in each stage are 168.15, 522.22, 215.31 and 316.79 kPa as well as 18.77, 6.7, 1.2 and 35.84 kPa for the floor, rack, forklift and conveyor load supports, respectively. A cross-hatched design causes a rise in capacity of the shear factor owing to the length of the span being in correlation with rectilinear fill. The filament of surface, made of ULTEM 9805, exhibits a level of roughness of 43.14 mu m on the pallet surface indicating better holding capacity and grip. A 9(circle) peak shift is comprehended with respect to XRD, indicating a compressive residual factor measured at 76.47 MPa.