Effect of the Operation and Humidification Temperatures on the Performance of a Pem Fuel Cell Stack on Dead-End Mode.

被引：0

作者：

Perez-Page, M. ^{[1
]}

Perez-Herranz, V. ^{[1
]}

机构：

[1] Univ Politecn Valencia, Depto Ingn Quim & Nucl, IEC, Valencia 46022, Spain

来源：

INTERNATIONAL JOURNAL OF ELECTROCHEMICAL SCIENCE | 2011年 / 6卷 / 02期

关键词：

PEM; Fuel cell stack; humidity and temperature; empirical modeling; monitoring voltage of individual cell; RELATIVE-HUMIDITY; DYNAMIC BEHAVIOR; WATER TRANSPORT; QUANTUM JUMPS; MEMBRANE; TECHNOLOGY; SCIENCE; 1960S; PEFC;

D O I：

暂无

中图分类号：

O646 [电化学、电解、磁化学];

学科分类号：

081704 ;

摘要：

Proton exchange membrane (PEM) fuel cells have attracted grate attention in recent years as a promising replacement for traditional engines. The performance of PEM fuel cells is known to be influenced by many parameters such as operation temperature and humidification of the gas streams. In this work, a testbench was developed to monitor and control a 300W fuel cell stack. Series of polarization curves with different fuel cell operation temperatures and humidification temperatures have been studied. From the polarization curves the values of kinetic parameters such as the Tafel slope and the cell resistance have been calculated with the fit of the experimental data to an empirical model. The effect of the fuel cell and humidification temperatures on the kinetic parameters has been studied.

引用

页码：492 / 505

页数：14

共 50 条

[1] Effect of the operation and humidification temperatures on the performance of a PEM Fuel Cell Stack
Perez-Page, M.
Perez-Herranz, V
[J]. PROTON EXCHANGE MEMBRANE FUEL CELLS 9, 2009, 25 (01): : 733 - 745
[2] A Factorial Study to Investigate the Purging Effect on the Performance of a Dead-End Anode PEM Fuel Cell Stack
Sasmito, A. P.
Ali, M. I.
Shamim, T.
[J]. FUEL CELLS, 2015, 15 (01) : 160 - 169
[3] Analysis of water management in PEM fuel cell stack at dead-end mode using direct visualization
Rahimi-Esbo, M.
Ranjbar, A. A.
Rahgoshay, S. M.
[J]. RENEWABLE ENERGY, 2020, 162 : 212 - 221
[4] Investigation of the Purging Effect on the Performance of Dead-End Anode PEM Fuel Cell Vehicle: a Driving Cycle Test
Gomez, Alberto
Sasmito, Agus P.
Shamim, Tariq
[J]. POLYMER ELECTROLYTE FUEL CELLS 13 (PEFC 13), 2013, 58 (01): : 229 - 242
[5] Effect of operating parameters on the transient performance of a polymer electrolyte membrane fuel cell stack with a dead-end anode
Gomez, Alberto
Raj, Abhishek
Sasmito, Agus P.
Shamim, Tariq
[J]. APPLIED ENERGY, 2014, 130 : 692 - 701
[6] Flow rate and humidification effects on a PEM fuel cell performance and operation
Guvelioglu, Galip H.
Stenger, Harvey G.
[J]. JOURNAL OF POWER SOURCES, 2007, 163 (02) : 882 - 891
[7] Nernst loss in fuel cells and fuel cell designs in dead-end mode
Standaert, F
Hemmes, K
Woudstra, N
[J]. PROCEEDINGS OF THE FOURTH INTERNATIONAL SYMPOSIUM ON CARBONATE FUEL CELL TECHNOLOGY, 1997, 97 (04): : 112 - 119
[8] Effect of Humidification of Gases on First Home Constructed PEM Fuel Cell Stack Potential
Ersan, Kemal
Irfan, A. R.
Tukek, Sami
[J]. GAZI UNIVERSITY JOURNAL OF SCIENCE, 2010, 23 (01): : 61 - 69
[9] The experimental analysis of a dead-end H2/O2 PEM fuel cell stack with cascade type design
Alizadeh, E.
Khorshidian, M.
Saadat, S. H. M.
Rahgoshay, S. M.
Rahimi-Esbo, M.
[J]. INTERNATIONAL JOURNAL OF HYDROGEN ENERGY, 2017, 42 (16) : 11662 - 11672
[10] Effect of clamping pressure on PEM fuel cell stack performance
Fekrazad, N.
Bergman, T. L.
[J]. PROCEEDINGS OF THE ASME HEAT TRANSFER DIVISION 2005, VOL 2, 2005, 376-2 : 127 - 139

← 1 2 3 4 5 →