Fluid flow and heat transfer with nail dipping method in mould during continuous casting process

The character and cause of sliver defect on IF steel sheet surface are studied by means of SEM, unstable flow in mould could induce surface velocity and level fluctuations, leading to surface defects during continuous casting of steel. The nozzle clogging is a serious problem during the continuous casting of steel, due to its influence on the casting operations and products quality. In this study, the nail dipping method for measuring surface velocity and flow direction in molten steel were employed. The fluid flow in mould of whole casting sequence was investigated, especially during the nozzle clogging conditions. The results showed that when nozzle clogging occurred in the 7th heat, the flow velocities on R and L side of nozzle were 0.280 and 0.402 m/s, respectively. The surface defect ratio of hot-rolled and cold-rolled plates increases with the increase of heat flux deviation on both sides of the mould copper. The different clogging per cent on both sides of the nozzle will lead to asymmetry flow, the surface velocity is higher with the small clogging per cent side compared to that of relatively large per cent clogging side.