Centrifuge-model tests on pore water pressure combined with vacuum and embankment loading

被引：0

作者：

Sawamura, Yasuo ^{[1
]}

Shiraga, Shinichiro ^{[2
]}

Hasegawa, Genki ^{[3
]}

Kimura, Makoto ^{[1
]}

机构：

[1] Kyoto Univ, Dept Urban Management, Kyoto, Japan

[2] Kinjo Rubber Corp, Civil Engn Div, Osaka, Japan

[3] Obayashi Corp, Civil Engn Construct Div, Tokyo, Japan

来源：

INTERNATIONAL JOURNAL OF PHYSICAL MODELLING IN GEOTECHNICS | 2022年 / 22卷 / 01期

关键词：

dedesign methods & aids; embankments; geotechnical engineering; PRELOADING CONSOLIDATION; BEARING CAPACITY; SOIL IMPROVEMENT; DRAIN;

D O I：

10.1680/jphmg.19.00025

中图分类号：

P5 [地质学];

学科分类号：

0709 ; 081803 ;

摘要：

Vacuum consolidation is a ground-improvement method in which negative pressure is applied to drain materials placed in a soft ground to consolidate the ground. Using the vacuum consolidation method, a soft ground can be consolidated without the shear deformation of the ground, and the combination of this method along with embankment loading enables the stable construction of the embankment and the suppression of the displacement of the surrounding ground. In this study, centrifuge-model experiments were conducted under a gravitational acceleration of 50g for the purpose of investigating the pore water pressure of the ground during both vacuum consolidation and embankment loading. Embankment loading was reproduced by a loading device consisting of an air cylinder and a loading plate, and vacuum consolidation was reproduced by depressurising the inside of a model drain using a vacuum pump. Three experimental cases were conducted: one case with only embankment loading and two cases with a combination of vacuum consolidation and embankment loading. From the experimental results, it was confirmed that in the ground where vacuum consolidation was applied, large negative pressure propagated near the drain material, and the increase in pore water pressure due to embankment loading was suppressed.

引用

下载

页码：1 / 13

页数：13

共 50 条

[1] Centrifuge model test of vacuum consolidation on soft clay combined with embankment loading
Shiraga, S.
Hasegawa, G.
Sawamura, Y.
Kimura, M.
PHYSICAL MODELLING IN GEOTECHNICS, VOL 2, 2018, : 1067 - 1072
[2] Lateral displacement under combined vacuum pressure and embankment loading
Chai, J.
Ong, C. Y.
Carter, J. P.
Bergado, D. T.
GEOTECHNIQUE, 2013, 63 (10): : 842 - 856
[3] Pore water pressure loading tests of a clay
Ohtsuka, S
Miyata, Y
Toyota, H
SLOPE STABILITY ENGINEERING, VOLS 1 & 2, 1999, : 731 - 734
[4] CENTRIFUGE MODEL TESTS OF EMBANKMENT ON SOIL FOUNDATION
Wang Xiaoyue
Cao Jie
Zheng Ruihua
TRENDS IN CIVIL ENGINEERING, PTS 1-4, 2012, 446-449 : 1842 - 1845
[5] An analytical model for the monitoring of pore water pressure inside embankment dams
Guo, X.
Baroth, J.
Dias, D.
Simon, A.
ENGINEERING STRUCTURES, 2018, 160 : 356 - 365
[6] Incremental model for pore water pressure and its applicability in centrifuge modelling
Tang Z.-G.
Wang Y.-Z.
Wang M.-W.
Sun R.
Liu Y.-P.
Yang Y.
Yantu Gongcheng Xuebao/Chinese Journal of Geotechnical Engineering, 2022, 44 : 25 - 29
[7] PORE WATER-PRESSURE CHANGES IN A ROAD EMBANKMENT
ANDERSON, MG
KNEALE, PE
HIGHWAY ENGINEER, 1980, 27 (05): : 11 - 17
[8] Model tests on jarofix embankment subject to strip loading
Anil Kumar Sinha
Vasant G. Havanagi
Jagdish T. Shahu
Arabian Journal of Geosciences, 2022, 15 (17)
[9] Development of a test apparatus for staged construction of embankment in geotechnical centrifuge model tests
Liu H.-Y.
Luo Q.
Wang W.-L.
Li P.-F.
Ma H.-F.
Zhang D.-Q.
Zhejiang Daxue Xuebao (Gongxue Ban)/Journal of Zhejiang University (Engineering Science), 2022, 56 (08): : 1504 - 1513
[10] Centrifuge model tests of geogrid-reinforced slope supporting a high embankment
Xu, H.
Ren, X.
Chen, J-N
Liu, C-N
Xia, L.
Liu, Y-W
GEOSYNTHETICS INTERNATIONAL, 2019, 26 (06) : 629 - 640

← 1 2 3 4 5 →