Numerical investigations of the slot blowing technique on the hypersonic vehicle for drag reduction

In this paper, the slot blowing flow-control technique is numerically studied for the hypersonic vehicle, aiming for skin friction drag reduction. Firstly, the influence patterns of the slot blowing parameters on friction drag reduction are analyzed based on a flat-plate boundary layer flow. It is concluded that there is an optimal blowing Mach number to optimize the drag reduction effect with other parameters unchanged, while as the increase of blowing pressure ratio, the skin friction drag reduction effect first increases and then remains almost invariant. On this basis, a slot blowing methodology is designed for a typical lifting-body hypersonic vehicle with a 10 mm slot installed on the middle of the windward side. Under the typical freestream condition of Mach 15 and 60 km altitude, numerical results indicate that the slot blowing with the blowing maximum Mach number 2 and blowing pressure ratio 1 could achieve a remarkable control effect of increasing the lift-drag ratio by about 10.55%. After that, the parametric study of slot blowing for the lifting-body vehicle reveals that when the slot height is increased from 10 mm to 20 mm, the lift-to-drag ratio rises slightly after paying the price of doubling the blowing mass flow rate, which indicates that increasing the slot height does not obtain a more efficient result. As for the effect of the slot position along the streamwise, moving the slot position forward could receive a higher total drag reduction rate with less blowing mass flow rate while also leads to a slight decrease of lift. Thus, the practical application of the slot blowing technique needs to consider the variations of the drag and lift comprehensively. (c) 2022 Elsevier Masson SAS. All rights reserved.