MECHANICAL PROPERTIES OF ADDITIVELY MANUFACTURED PEEK COMPONENTS USING FUSED FILAMENT FABRICATION

Polyether ether ketone (PEEK) is introduced as a material for the additive manufacturing process called fused filament fabrication (FFF), as opposed to selective laser sintering (SLS) manufacturing. FFF manufacturing has several advantages over SLS manufacturing, including lower initial machine purchases costs, ease of use (spool of filament material vs powder material), reduced risk of material contamination and/or degradation, and safety for the users of the equipment. PEEK is an excellent candidate for FFF due to its low moisture absorption as opposed to other common FFF materials, such as Acrylonitrile Butadiene Styrene (ABS). PEEK has been processed into a filament and samples have been manufactured using several build orientations and extrusion paths. The samples were used to conduct tensile, compression, flexural, and impact testing to determine mechanical strength characteristics such as yield strength, modulus of elasticity, ultimate tensile strength and maximum elongation, etc. All tests were conducted at room temperature. A microscope analysis was also conducted to show features on the failures surfaces. The mechanical property results from this study are compared to other published results using traditional thermo-plastic manufacturing techniques, such injection molding. Tensile testing was conducted at three raster orientations, 0 degrees, 90 degrees and alternating between 0 degrees and 90 degrees. Average ultimate tensile stresses were determined to be 73 MPa for 0 degrees orientation, and 54 MPa for 90 degrees orientation, with alternating 0 degrees/90 degrees orientations of 66.5 MPa. Compression testing was conducted at two raster orientations, 0 degrees and alternating between 0 degrees and 90 degrees. Average ultimate strength for the single orientation direction was 80 degrees.9 MPa with the alternating orientations at 72.8 MPa. Flexural testing was conducted at three raster orientations, 0 degrees, 90 degrees and alternating between 0 degrees. and 90 degrees. Ultimate flexural stress was determined to be 111.7 MPa for 0 degrees, 79.7 MPa for 90 degrees, and 95.3 MPa for orientations alternating between 0 degrees and 90 degrees Finally, impact testing was conducted at three raster orientations, 0 degrees, 90 degrees and alternating between 0 degrees and 90 degrees. Average impact energy absorbed was determined to be 17.5 Nm in the 0 degrees orientation, 1.4 Nm in the 90 degrees orientation, and 0 degrees.7 Nm for the alternating 0 degrees and 90 degrees orientations.