Numerical simulation of THMC coupling temperature prediction for fractured horizontal wells in shale oil reservoir

In order to study the effects of different parameters in hydraulic fracturing on formation temperature after lowtemperature fracturing fluid is injected into high-temperature reservoir, in this paper, considering (1) osmotic pressure and capillary pressure (2) microthermal effect (heat conduction, heat convection, heat expansion, viscous dissipation) (3) the coupling processes of temperature (T), hydraulic, (H) mechanical (M) and chemical (C) in hydraulic fracturing process, and the coupled temperature prediction model of oil-water two-phase THMC based on discrete fractures is established. The effects of fracturing fluid temperature, reservoir temperature, dimensionless conductivity, Young's modulus, injection rate, cluster spacing, and proportion of branch fracture area on reservoir and fracture temperature during the pumping and shut-in stages of shale oil reservoir were studied. The results show (1) For formations with different reservoir temperatures, the temperature drop at the fracture was approximately 97% from the start of the operation to the end of the 30-day shut-in. The saturation change caused by fracturing fluid filtration is much larger than the temperature change caused by heat transfer, and it is found that the temperature and saturation change mainly occur in the early shut-in period (2) Imbibition accelerates the filtration loss of fracturing fluid. During pumping, the bottom hole temperature with imbibition considered is lower than that without imbibition considered. The temperature curve with imbibition considered begins to deviate about 10 min after pumping, but the final temperature tends to be the same, (3) When the fracturing fluid is pumped at high pressure, the fracture and matrix will be deformed, which will improve the porosity and permeability of the near well zone, thus speeding up the heat transfer rate. The high Young's modulus inhibits the increase of permeability. Compared with the young's modulus of 40 GPa and 20 GPa, the increase of permeability decreases by 9% (4) When the well was shut in for 30 days, the cluster spacing was greater than 20 m, and the temperature change around the fracture did not affect the clusters on both sides. The spacing between the clusters was 5 m, and the perforation clusters on both sides had a significant effect on the temperature. The temperature of the reservoir between the two adjacent clusters dropped from 393 K to 385 K. When there is a branch fracture, the small cluster spacing is equivalent to increasing the complexity of the fracture and accelerating the initial heat transfer rate. (5) High injection temperature, high dimensionless conductivity, low Young's modulus and low pumping rate are conducive to the heat transfer of fracturing fluid in the formation.