Modelling of NO and N2O emissions from biomass-fired circulating fluidized bed combustors

A model for NO and N2O emissions from biomass-fired circulating fluidized bed (CFB) combustors has been developed and evaluated in this study. All the model parameters were chosen for a typical woody biomass-pinewood chips. Both drying and devolatilization of biomass particles were modelled with limited rates, which were selected from the literature based on woody biomass fuels. The partition of fuel-nitrogen between volatiles and char was also specifically chosen for pinewood based on available experimental data from the literature. Volatile nitrogen was assumed to consist of NH3, HCN and N-2 with the distribution between three species as input parameters to the model. Twenty-five homogenous and heterogeneous global chemical reactions, were included in the model, of which 20 reactions represents the global fuel-nitrogen reactions. Both gaseous and solid phase were assumed to be in plug flow. The model has been applied to the modelling of a 12 MWth CFB boiler. The predicted N2O emissions were always less than 5 ppmv for pinewood combustion, which was consistent with the experimental results. The predicted NO emissions increased with the total excess air of the riser and the fuel-N content while the predicted percentage conversion of fuel-N to NO decreased with increasing fuel-N content. The NO emissions were also predicted to decrease with increasing primary zone stoichiometry. These predictions agree with the experimental results, The predicted NO emissions decreased slightly with increasing bed temperature, whereas experiments showed that NO emissions slightly increased with bed temperature for birch chips combustion and did not change with bed temperature for fir chips combustion. Sensitivity analyses reveal that the reaction between NO and char is the key reaction to determine the NO emissions. (C) 2001 Elsevier Science Ltd. All rights reserved.