Ordered to Isotropic Morphology Transition in Pattern-Directed Dewetting of Polymer Thin Films on Substrates with Different Feature Heights

Controlled dewetting of a thin polymer film on a topographically patterned substrate is an interesting approach for aligning isotropic dewetted structures. In this article, we investigate the influence of substrate feature height (H-S) on the dewetting pathway and final pattern morphology by studying the dewetting of polystyrene (PS) thin films on grating substrates with identical periodicity (lambda(p) = 1.5 mu m), but H-S varying between 10 nm and 120 nm. We identify four distinct categories of final dewetted morphology, with different extent of ordering: (1) array of aligned droplets (H-S approximate to 120 nm); (2) aligned undulating ribbons (H-S approximate to 70-100 nm); (3) multilength scale structures with coexisting large droplets uncorrelated to the substrate and smaller droplets/ribbons aligned along the stripes (H-S approximate to 40-60 nm); and (4) large droplets completely uncorrelated to the substrate (H-S < 25 nm). The distinct morphologies across the categories are attributed to two major factors: (a) whether the as-cast film is continuous (H-S <= 80 nm) or discontinuous (H-S >= 100 nm) and (b) in case of a continuous film, whether the film ruptures along each substrate stripe (H-S >= 70 nm) or with nucleation of random holes that are not correlated to the substrate features (H-S <= 60 nm). While the ranges of H-S values indicated in the parentheses are valid for PS films with an equivalent thickness (h(E)) approximate to 50.3 nm on a flat substrate, a change in h(E) merely alters the cut-off values of H-S, as the final dewetted morphologies and transition across categories remain generically unaltered. We finally show that the structures obtained by dewetting on different H-S substrates exhibits different levels of hydrophobicity because of combined spatial variation of chemical and topographic contrast along the surface. Thus, the work reported in this article can find potential application in fabricating surfaces with controlled wettability.