Computational Fluid Dynamics (CFD) simulation of liquid column separation in pipe transients

The present study deals with the computational simulation of transient events of water hammer and column separation in a water pipeline system. Three-dimensional CFD simulations based on the Finite-Volume (FV) approach are performed to predict pressure fluctuations and to visualize liquid column separation/rejoining caused by the sudden closure of a valve located at the upstream end of the pipe. Explanation of vaporous cavitation phenomena is also presented. The Volume of Fluid (VOF) model and Schnerr-Sauer cavitation model are used to describe the multiphase flow and the transient vaporous cavitation, respectively. Moreover, the shear-stress transport (SST) turbulence model is applied to model the Reynolds stresses using the Boussinesq hypothesis. Present results are compared with available experimental and numerical results from the literature. The comparisons show that the present method gives adequate results. Also, the 3D model adopted is deemed physically superior to the existing 1D models as it removes the restriction of the 1D models that vapor cavities, when formed, fill the whole cross-section of the pipe without radial variation. In addition, 1D models are not able to predict the stratification effect due to density variation of the two phases. Consequently, the 3D model can better visualize the phenomenon of liquid column separation/rejoining in pipes than 1D models. (C) 2020 The Authors. Published by Elsevier B.V. on behalf of Faculty of Engineering, Alexandria University.