Corrosion Behaviors of Hydroxyapatite Coated by Electrodeposition Method of Ti6Al4V, Ti and AISI 316L SS Substrates

Electrodeposition method was used to obtain hydroxyapatite (HAP) coatings on Ti6Al4V, Ti and AISI 316L SS substrates. Electrodeposition solution is prepared as Ca(NO3)(2) center dot 4H(2)O and (NH4)H2PO4. Additionally, three different pretreatment surface operations (PTSO) (HNO3, anodic polarization, base-acid) were applied to the substrates. Surface morphology of HAP coated substrates were characterized by SEM, EDS, XRD. HAP coatings were successfully deposited on Ti6Al4V, AISI 316L SS and Ti substrates Corrosion behavior of uncoated and HAP coated substrates were examined in the Ringer and 0.9% NaCl solutions. The XRD, SEM-EDS results supported that HAP formation on the substrates. i(cor) values for all three HAP coated substrates are higher than uncoated substrates This showed that, electrochemical deposition HAP coating could not prevent the corrosion. The lowest corrosion rates were founded HNO3 PTSO substrates.