Through-thickness shear texture of the twin-roll cast AA6016 sheet after asymmetric rolling and its recrystallization behavior

In this study, we investigate the through-thickness shear texture F{111}<112> and r-cube {001}<110> of the AA6016 twin-roll cast sheet under asymmetric rolling (ASR) via simulation and experiments and its recrystallization behaviors after annealing at 330 degrees C for 60 min. ASR can be achieved by controlling the velocity ratio of the upper and lower rollers to 2.0. Finite element (FE) simulations in case of ASR are used to determine the shear strain through the sheet thickness. Polycrystal simulations are conducted based on the FE results to predict the shear texture. Subsequently, the crystallographic texture of the sheet obtained with unidirectional ASR processes is evaluated. The experimental results show that the F-texture is obtained and that the inhomogeneity was distributed. The F-texture intensity of the sample near the lower roller (sample A) was greater than that of the sample near the upper roller (sample B). The simulation results are in good agreement with the measured results. However, the simulation results obtained with respect to the r-cube texture are greater than the measured results, resulting in considerable deviation. Further, the different recrystallization behaviors of the F-oriented grains (F-grains) are determined based on the sheet thickness. The F-grains associated with sample A can be obtained based on the rolling texture contributed by continuous recrystallization, whereas those associated with sample B can be achieved via discontinuous recrystallization. A considerably inhomogeneous microstructure and texture are observed through the sheet thickness after annealing. (C) 2021 The Authors. Published by Elsevier B.V.