Comparative wear under four different tribological conditions of acetylene enhanced cross-linked ultra high molecular weight polyethylene

被引：54
|
作者：
Marrs, H [1 ]
Barton, DC
Jones, RA
Ward, IM
Fisher, J
Doyle, C
机构：
[1] Univ Leeds, Sch Mech Engn, Leeds LS2 9JT, W Yorkshire, England
[2] Univ Leeds, IRC Polymer Sci & Technol, Dept Phys & Astron, Leeds LS2 9JT, W Yorkshire, England
[3] Howmedia Worldwide Res & Dev, Staines, Middx, England
来源：
JOURNAL OF MATERIALS SCIENCE-MATERIALS IN MEDICINE | 1999年 / 10卷 / 06期
基金：
英国工程与自然科学研究理事会;
关键词：
D O I：
10.1023/A:1026469522868
中图分类号：
R318 [生物医学工程];
学科分类号：
0831 ;
摘要：
In this study, the wear of ultra high molecular weight polyethylene (UHMWPE) (Grade RCH 1000) crosslinked by gamma irradiation in acetylene was compared to virgin (non-irradiated) UHMWPE using four different wear configurations: (i) unidirectional motion with a smooth counterface, (ii) multidirectional motion with a smooth counterface, (iii) unidirectional motion with a rough counterface and (iv) multidirectional motion with a rough counterface. (C) 1999 Kluwer Academic Publishers.
引用
收藏
页码：333 / 342
页数：10
相关论文
共 50 条
  • [1] Comparative wear under four different tribological conditions of acetylene enhanced cross-linked ultra high molecular weight polyethylene
    H. Marrs
    D. C. Barton
    R. A. Jones
    I. M. Ward
    J. Fisher
    C. Doyle
    Journal of Materials Science: Materials in Medicine, 1999, 10 : 333 - 342
  • [2] Comparative wear tests of ultra-high molecular weight polyethylene and cross-linked polyethylene
    Harsha, A. P.
    Joyce, Tom J.
    PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART H-JOURNAL OF ENGINEERING IN MEDICINE, 2013, 227 (H5) : 600 - 608
  • [3] A comparison of the wear and physical properties of silane cross-linked polyethylene and ultra-high molecular weight polyethylene
    Sakoda, H
    Voice, AM
    McEwen, HMJ
    Isaac, GH
    Hardaker, C
    Wroblewski, BM
    Fisher, J
    JOURNAL OF ARTHROPLASTY, 2001, 16 (08): : 1018 - 1023
  • [4] Tradeoffs amongst fatigue, wear, and oxidation resistance of cross-linked ultra-high molecular weight polyethylene
    Atwood, Sara A.
    Van Citters, Douglas W.
    Patten, Eli W.
    Furmanski, Jevan
    Ries, Michael D.
    Pruitt, Lisa A.
    JOURNAL OF THE MECHANICAL BEHAVIOR OF BIOMEDICAL MATERIALS, 2011, 4 (07) : 1033 - 1045
  • [5] Computational Wear Simulation on Cross-linked Ultra-high Molecular Weight Polyethylene Artificial Hip Joints
    Gao, Zirui
    Liu, Feng
    Liu, Yao
    Jiao, Duoduo
    Li, Hongwei
    Jixie Gongcheng Xuebao/Journal of Mechanical Engineering, 2021, 57 (21): : 202 - 210
  • [6] Comparative wear and wear debris under three different counterface conditions of crosslinked and non-crosslinked ultra high molecular weight polyethylene
    Endo, MM
    Barbour, PSM
    Barton, DC
    Fisher, J
    Tipper, JL
    Ingham, E
    Stone, MH
    BIO-MEDICAL MATERIALS AND ENGINEERING, 2001, 11 (01) : 23 - 35
  • [7] Effect of the compression ratio on wear properties of slightly cross-linked ultra-high molecular weight polyethylene, crystallized under uniaxial compression
    Ohta, M
    Hyon, SH
    Kang, YB
    Murakami, S
    Kohjiya, S
    Oka, M
    Tsutsumi, S
    WEAR, 2001, 250 : 145 - 151
  • [8] Surface cross-linked ultra high molecular weight polyethylene by emulsified diffusion of dicumyl peroxide
    Kayandan, Sanem
    Doshi, Brinda N.
    Oral, Ebru
    Muratoglu, Orhun K.
    JOURNAL OF BIOMEDICAL MATERIALS RESEARCH PART B-APPLIED BIOMATERIALS, 2018, 106 (04) : 1517 - 1523
  • [9] Wear behaviour of cross-linked polyethylene assessed in vitro under severe conditions
    Affatato, S
    Bersaglia, G
    Rocchi, M
    Taddei, P
    Fagnano, C
    Toni, A
    BIOMATERIALS, 2005, 26 (16) : 3259 - 3267
  • [10] Reduction of total knee replacement wear with vitamin E blended highly cross-linked ultra-high molecular weight polyethylene
    Vaidya, C.
    Alvarez, E.
    Vinciguerra, J.
    Bruce, D. A.
    DesJardins, J. D.
    PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART H-JOURNAL OF ENGINEERING IN MEDICINE, 2011, 225 (H1) : 1 - 7
12345