Laccase-HBT bleaching of eucalyptus kraft pulp: Influence of the operating conditions

Different operating conditions (viz. pulp consistency, oxygen pressure and treatment time) in the biobleaching of eucalyptus kraft pulp with the laccase-HBT system was tested in order to describe their effect and normalize a biobleaching protocol. A high O-2 pressure (0.6 MPa) was found to result in improved laccase-assisted delignification of the pulp. Also, a high pulp consistency (10%) and a short treatment time (2 h) proved the best choices with a view to obtaining good pulp properties (kappa number and ISO brightness) under essentially mild conditions. The laccase-HBT treatment was found to result in slight delignification (in the form of a 20-27% decrease in kappa number); however, an alkaline extraction stage raised delignification to 41-45%, a much higher level than those obtained in the control tests (16-23%). Also, the use of hydrogen peroxide in the extraction stage resulted in improved brightness (14-19%), but in scarcely improved delignification (4-7%). Treating the pulp with the laccase-HBT system reduced the amount of hydrogen peroxide required for subsequent alkaline bleaching by a factor of 3-4 relative to control tests. (c) 2008 Elsevier Ltd. All rights reserved.