Optimal Injection Parameters for Enhancing Coalbed Methane Recovery: A Simulation Study from the Shizhuang Block, Qinshui Basin, China

The injection of N-2 into coal reservoir has great potential in improving recovery of coalbed methane (CBM). In this study, a numerical model was established based on the GEM component model to evaluate the influences of different N-2 injection parameters (production injection well spacing, gas injection timing, gas injection duration, gas injection rate, and the bottom-hole injection pressure) on the production of CBM in the Shizhuang Block of Qinshui Basin, China. Based on the economic benefit of CBM production, the production increasing rate and nitrogen replacement ratio were established to optimize the N-2 injection parameters. The results show that (1) the production injection well spacing had the greatest influence on CBM production, followed by injection duration and the bottom-hole injection pressure, and injection timing and injection rate had a relatively small influence. (2) With increasing gas injection duration, injection rate, and the bottom-hole injection pressure, the rate of production increased and the nitrogen replacement ratio decreased. (3) The optimal N-2 injection scheme was revealed with the production injection well spacing of 180 m, the injection timing of a second year after gas production, an injection duration of 7 years, an injection rate of 5000 m(3)/d, and a bottom-hole injection pressure of 10 MPa. Under these conditions, the rate of production increasing rate, the nitrogen displacement ratio, and the regional recovery of the four production wells were 18.14%, 0.5, and 48.96%, respectively, some 8.88% higher than that without nitrogen displacement, showing good effect in terms of CBM production.