Detailed investigation of a pulverized fuel swirl flame in CO2/O2 atmosphere

A novel approach to oxycoal flame stabilization has been developed at the Institute of Heat and Mass Transfer at RWTH Aachen University [D. Toporov, M. Forster, R. Kneer, in: Third Int. Conf. on Clean Coal Technologies for Our Future, Cagliari, Sardinia, Italy, 15-17 May 2007]. The swirl burner design and its operating conditions have been adjusted in order to enforce CO formation thus stabilizing the flame and obtaining a full burnout at levels of O(2) content in the O(2)/CO(2) mixture Similar to those in air. The paper presents results of detailed numerical and experimental investigations of a stable oxy-fired pulverized coal swirl flame (type-2) obtained with a 21 vol% O(2) concentration. The combustion tests Were performed in a vertical pilot-scale furnace (100 kW(th)) ill the framework of the OXYCOAL-AC research project aiming to develop a membrane-based oxyfuel process. The experimental results concerning gas velocities, gas and particle temperatures, and gas compositions are presented and discussed, focusing oil the underlying mechanisms as well as on the aerodynamics of the oxycoal flame. A comparison between measurements and simulations has shown the validity of the numerical method used. The reported data set call be used for validation of numerical models developed for prediction of oxyfuel combustion. (C) 2008 The Combustion Institute. Published by Elsevier Inc. All rights reserved.