Stagnation-point reverse-flow combustor performance with liquid fuel injection

被引:0
|
作者
Crane, John [1 ]
Neumeier, Yedidia [1 ]
Jagoda, Jeff [1 ]
Seitzman, Jerry [1 ]
Zinn, Ben T. [1 ]
机构
[1] Georgia Inst Technol, Dept Aerosp Engn, Atlanta, GA 30332 USA
关键词
stagnation point reverse flow combustor; SPRF combustor; liquid fuel; Jet-A; heptane; ultra-low; NOx; CO; emissions;
D O I
暂无
中图分类号
TE [石油、天然气工业]; TK [能源与动力工程];
学科分类号
0807 ; 0820 ;
摘要
This paper describes an investigation of the performance of the recently developed ultra low emissions, Stagnation-Point Reverse-Flow (SPRF) Combustor when burning liquid fuels (Jet-A and heptane). This study has been undertaken because of the need to bum liquid fuels with low emissions in gas turbines that are used, for example, in aircraft engines, land-based power generation, and marine applications. In contrast with state of the art combustors, in which the reactants and products enter and leave the combustor through opposite ends of the combustor, the reactants and products enter and leave the SPRF combustor through the same plane opposite a closed end. The design of the SPRF combustor allows mixing of reactants with hot combustion products and radicals within the combustor, prior to combustion. Thus, no external premixing of fuel and air is required. Additionally, since the air and fuel enter opposite the closed end of the combustor, they must stagnate near the closed end, thus establishing a region of low velocity just upstream of the closed end that helps stabilize the combustion process. This apparently produces a low temperature, stable, distributed reaction zone. Previous studies with the SPRF combustor investigated its performance while burning natural gas. This paper presents the results of SPRF combustor studies using liquid fuels, both heptane and Jet-A. The performance of the combustor was investigated using an airblast fuel injector, which is suitable for the low fuel flow rates used in laboratory experiments. To reduce pressure losses across the injector, a diffuser was incorporated into the airblast injector. It was found that stable combustor operation was achieved burning Jet-A with emissions of less than 1 ppm NO, and 5 ppm CO, pressure losses less than 5 percent, and a power density on the order of 10 MW/m(3) in atmospheric pressure. This power density would linearly scale to 300 MW/m(3) in a combustor at a pressure of 30 atmospheres.
引用
收藏
页码:927 / 936
页数:10
相关论文
共 50 条
  • [1] Flame structure and stabilization mechanisms in a stagnation-point reverse-flow combustor
    Bobba, Mohan K.
    Gopalakrishnan, Priya
    Periagaram, Karthik
    Seitzman, Jerry M.
    [J]. JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER-TRANSACTIONS OF THE ASME, 2008, 130 (03):
  • [2] Continuously-staged NH3 oxidation in a stagnation-point reverse-flow combustor for low NOx emissions
    Giuntini, Lorenzo
    Novelli, Chiara
    Kamal, M. Mustafa
    Cafiero, Marianna
    Galletti, Chiara
    Coussement, Axel
    Parente, Alessandro
    [J]. PROCEEDINGS OF THE COMBUSTION INSTITUTE, 2024, 40 (1-4)
  • [3] COMBUSTION OF LIQUID FUEL SPRAYS IN STAGNATION-POINT FLOW
    CHEN, ZH
    LIN, TH
    SOHRAB, SH
    [J]. COMBUSTION SCIENCE AND TECHNOLOGY, 1988, 60 (1-3) : 63 - 77
  • [4] Development and analysis of a LTCC micro stagnation-point flow combustor
    Wu, Ming-Hsun
    Yetter, Richard A.
    [J]. JOURNAL OF MICROMECHANICS AND MICROENGINEERING, 2008, 18 (12)
  • [5] Solidification of a supercooled liquid in stagnation-point flow
    Lambert, RA
    Rangel, RH
    [J]. INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 2003, 46 (21) : 4013 - 4021
  • [6] NUMERICAL INVESTIGATION OF A STAGNATION POINT REVERSE FLOW COMBUSTOR
    Cui, Yufeng
    Lu, Xuan
    Xu, Gang
    Chen, Jianli
    Nie, Chaoqun
    Huang, Weiguang
    [J]. PROCEEDINGS OF THE ASME TURBO EXPO 2008, VOL 3, PTS A AND B, 2008, : 507 - 513
  • [7] CONTOURS FOR STAGNATION-POINT MASS INJECTION IN HYPERSONIC FLOW
    WANG, CY
    [J]. AIAA JOURNAL, 1964, 2 (01) : 178 - 179
  • [8] Condensation of a Quiescent Vapor by a Stagnation-Point Liquid Flow
    Balasubramaniam, R.
    Rame, E.
    [J]. JOURNAL OF HEAT TRANSFER-TRANSACTIONS OF THE ASME, 2018, 140 (05):
  • [9] Experiment on effect of inlet airflow on performance of a reverse-flow combustor
    Zhao, Shuo
    Huang, Zhang-Fang
    Cheng, Sheng-Jun
    [J]. Hangkong Dongli Xuebao/Journal of Aerospace Power, 2015, 30 (06): : 1293 - 1297
  • [10] THE REVERSE-FLOW SPOUTED BED COMBUSTOR
    ARBIB, HA
    LEVY, A
    [J]. COMBUSTION SCIENCE AND TECHNOLOGY, 1982, 29 (1-2) : 83 - 86