Hot Deformation Behavior and Microstructure Evolution of a TiBw/Near -Ti Composite with Fine Matrix Microstructure

The hot deformation behavior and microstructure evolution of a 7.5 vol.% TiBw/near -Ti composite with fine matrix microstructure were investigated under the deformation conditions in a temperature range of 800-950 degrees C and strain rate range of 0.001-1 s(-1) using plane strain compression tests. The flow stress curves show different characteristics according to the various deformation conditions. At a higher strain rate (1 s(-1)), the flow stress of the composite continuously increases until a peak value is reached. The activation energy is 410.40 kJ/mol, much lower than the activation energy of as-sintered or as-forged composites. The decreased activation energy is ascribed to the breaking of the TiBw reinforcement during the multi-directional forging and the resultant fine matrix microstructure. Refined reinforcement and refined matrix microstructure significantly improve the hot deformation ability of the composite. The deformation conditions determine the morphology and fraction of and phases. At 800-900 degrees C and 0.01 s(-1) the matrix grains are much refined due to the continuous dynamic recrystallization (CDRX). The processing map is constructed based on the hot deformation behavior and microstructure evolution. The optimal hot processing window is determined to be 800-950 degrees C/0.001-0.01 s(-1), which lead to CDRX of primary grains or dynamic recovery (DRV) and dynamic recrystallization (DRX) of phase.