Improving tensile and compressive properties of magnesium alloy plates by pre-cold rolling

被引：251
|
作者：
Song, Bo [1 ]
Xin, Renlong [1 ,2 ]
Chen, Gang [1 ]
Zhang, Xiyan [1 ,2 ]
Liu, Qing [1 ,2 ]
机构：
[1] Chongqing Univ, Coll Mat Sci & Engn, Chongqing 400045, Peoples R China
[2] Chongqing Univ, Natl Engn Res Ctr Magnesium Alloys, Chongqing 400045, Peoples R China
来源：
SCRIPTA MATERIALIA | 2012年 / 66卷 / 12期
关键词：
AZ31; Yield asymmetry; Cold rolling; Twinning; AZ31 MG ALLOY; GRAIN-SIZE; MG-3AL-1ZN ALLOY; DUCTILITY; BEHAVIOR; DEFORMATION; TEXTURE; EVOLUTION; TWINS;
D O I：
10.1016/j.scriptamat.2012.02.047
中图分类号：
TB3 [工程材料学];
学科分类号：
0805 ; 080502 ;
摘要：
The tensile and compressive properties of AZ31 plates were dramatically enhanced by pre-rolling with small thickness reduction along the transverse direction. The yield asymmetry was also greatly improved. This is attributed to the subdivision of grains by introducing extension twin boundaries. Moreover, the introduction of twin boundaries had less impact on the slope of the stage Ill strain hardening curve, while it slightly prolonged the stage III curve in compression. The deformation mechanism of the materials containing twin lamellae was also discussed. (C) 2012 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.
引用
收藏
页码：1061 / 1064
页数：4
相关论文
共 50 条
  • [1] Improving tensile and compressive properties of magnesium alloy rods via a simple pre-torsion deformation
    Guo, Ning
    Song, Bo
    Guo, Changfa
    Xin, Renlong
    Liu, Qing
    MATERIALS & DESIGN, 2015, 83 : 270 - 275
  • [2] Improving age hardening response and mechanical properties of a new Mg-RE alloy via simple pre-cold rolling
    Li, Guoqiang
    Zhang, Jinghuai
    Wu, Ruizhi
    Liu, Shujuan
    Song, Bo
    Jiao, Yufeng
    Yang, Qiang
    Hou, Legan
    JOURNAL OF ALLOYS AND COMPOUNDS, 2019, 777 : 1375 - 1385
  • [3] Effect of Pre-cold Rolling-Induced Twins and Subsequent Precipitated ω-Phase on Mechanical Properties in a β-Type Ti–Mo Alloy
    Li Xiang
    Xiao-Hua Min
    Xin Ji
    Satoshi Emura
    Cong-Qian Cheng
    Koichi Tsuchiya
    Acta Metallurgica Sinica (English Letters), 2018, 31 : 604 - 614
  • [4] Improving the mechanical properties of a ZM61 magnesium alloy by pre rolling and high strain rate rolling
    Jiang, Jimiao
    Wu, Jiang
    Ni, Song
    Yan, Hongge
    Song, Min
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2018, 712 : 478 - 484
  • [5] Compressive and tensile properties of CuZrAl alloy plates containing martensitic phases
    Wei, X. F.
    Sun, Y. F.
    Guan, S. K.
    Terada, D.
    Shek, C. H.
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2009, 517 (1-2): : 375 - 380
  • [6] Effect of Pre-cold Rolling-Induced Twins and Subsequent Precipitated ω-Phase on Mechanical Properties in a β-Type Ti-Mo Alloy
    Xiang, Li
    Min, Xiao-Hua
    Ji, Xin
    Emura, Satoshi
    Cheng, Cong-Qian
    Tsuchiya, Koichi
    ACTA METALLURGICA SINICA-ENGLISH LETTERS, 2018, 31 (06) : 604 - 614
  • [7] Effect of Pre-cold Rolling-Induced Twins and Subsequent Precipitated x-Phase on Mechanical Properties in a β-Type Ti–Mo Alloy
    Li Xiang
    Xiao-Hua Min
    Xin Ji
    Satoshi Emura
    Cong-Qian Cheng
    Koichi Tsuchiya
    ActaMetallurgicaSinica(EnglishLetters), 2018, 31 (06) : 604 - 614
  • [8] Influence of Cold Rolling and Annealing on the Tensile Properties of Aluminum 7075 Alloy
    Rao, A. C. Umamaheshwer
    Vasu, V.
    Govindaraju, M.
    Srinadh, K. V. Sai
    INTERNATIONAL CONFERENCE ON ADVANCES IN MANUFACTURING AND MATERIALS ENGINEERING (ICAMME 2014), 2014, 5 : 86 - 95
  • [9] Improving tensile and compressive strengths of magnesium by blending it with aluminium
    Thakur, S. K.
    Paramsothy, M.
    Gupta, M.
    MATERIALS SCIENCE AND TECHNOLOGY, 2010, 26 (01) : 115 - 120
  • [10] Improved mechanical properties of AZ31 magnesium alloy plates by pre-rolling followed by warm compression
    Zhang, Hua
    Yan, Yan
    Fan, Jianfeng
    Cheng, Weili
    Roven, Hans Jorgen
    Xu, Bingshe
    Dong, Hongbiao
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2014, 618 : 540 - 545
12345