Compressor Blade Vibration Measurements Using Blade Image Velocimetry

被引:2
|
作者
Mikrut, Paul L. [1 ]
Morris, Scott C. [1 ]
Cameron, Joshua D. [1 ]
机构
[1] Univ Notre Dame, Dept Aerosp & Mech Engn, Hessert Lab, Notre Dame, IN 46556 USA
关键词
MODES;
D O I
10.1115/1.4030423
中图分类号
O42 [声学];
学科分类号
070206 ; 082403 ;
摘要
This paper discusses the application of a novel vibration measurement technique, termed blade image velocimetry (BIV), to a high-speed axial compressor. Measurements of compressor blade vibration can be difficult to obtain and are critical to aeromechanical design validation. The measurement technique discussed in this paper used a commercial particle image velocimetry (PIV) system and was developed as an alternative to conventional measurement techniques such as strain gages and blade tip timing (BTT). The measurement principles and error analysis are reviewed. Methods for estimating the magnitude of random noise corrupting the measurement and validating the vibration amplitude estimates are presented. The technique was validated using a 1.5 stage axial compressor operating at low shaft speed, where it measured the tip velocity to within 0.02% of the true value. The technique was then used to investigate blade vibration at high shaft speed. Low amplitude vibrations in first bending and first torsion were discovered when the compressor was operated at design air-mass flow rate. These vibrations had a maximum tip deflection of 15 mu m for bending and 7 mu m for torsion. The vibration amplitude for first bending and first torsion tripled when the compressor was operated at low air mass-flow rate, corresponding to deep stall. Furthermore, excitation of the third eigenmode was also measured. The maximum tip deflections of the first three eigenmodes when the compressor was operated at deep stall were 47 mu m, 27 mu m, and 15 mu m, respectively.
引用
收藏
页数:8
相关论文
共 50 条
  • [1] Rotor blade-to-blade measurements using particle image velocimetry
    Tisserant, D
    Breugelmans, FAE
    [J]. JOURNAL OF TURBOMACHINERY-TRANSACTIONS OF THE ASME, 1997, 119 (02): : 176 - 181
  • [2] Experimental investigation of the blade-to-blade flow in a compressor rotor by digital particle image velocimetry
    Balzani, N
    Scarano, F
    Riethmuller, RL
    Breugelmans, FAE
    [J]. JOURNAL OF TURBOMACHINERY-TRANSACTIONS OF THE ASME, 2000, 122 (04): : 743 - 750
  • [3] Measurements of the orthogonal blade–vortex interaction using a particle image velocimetry technique
    R. B. Green
    C. J. Doolan
    R. M. Cannon
    [J]. Experiments in Fluids, 2000, 29 : 369 - 379
  • [4] BLADE TIP CLEARANCE AND BLADE VIBRATION MEASUREMENTS USING A MAGNETORESISTIVE SENSOR
    Tomassini, R.
    Rossi, G.
    Brouckaert, J-F.
    [J]. 11TH EUROPEAN CONFERENCE ON TURBOMACHINERY: FLUID DYNAMICS AND THERMODYNAMICS, 2015,
  • [5] Measurements of the orthogonal blade-vortex interaction using a particle image velocimetry technique
    Green, RB
    Doolan, CJ
    Cannon, RM
    [J]. EXPERIMENTS IN FLUIDS, 2000, 29 (04) : 369 - 379
  • [6] Laser velocimetry and blade pressure measurements of a blade-vortex interaction
    Gorton, SA
    Poling, DR
    Dadone, L
    [J]. JOURNAL OF THE AMERICAN HELICOPTER SOCIETY, 1995, 40 (02) : 15 - 23
  • [7] Vibration Control of a Compressor Blade Using Position and Velocity Feedback
    Kandil, Ali
    Kamel, Magdy
    [J]. INTERNATIONAL JOURNAL OF ACOUSTICS AND VIBRATION, 2019, 24 (01): : 97 - 112
  • [8] HOLOGRAPHIC MEASUREMENT OF COMPRESSOR BLADE, TURBINE BLADE AND AIRFRAME PANEL VIBRATION DISTRIBUTION
    ALWANG, WG
    BURR, R
    CAVANAUG.LA
    [J]. SAE TRANSACTIONS, 1969, 78 : 105 - &
  • [9] Vibration analysis for detecting failure of compressor blade
    Rao, A. Rama
    Dutta, B. K.
    [J]. ENGINEERING FAILURE ANALYSIS, 2012, 25 : 211 - 218
  • [10] DETECTION AND STUDY OF COMPRESSOR-BLADE VIBRATION
    HOHENBER.R
    [J]. EXPERIMENTAL MECHANICS, 1967, 7 (06) : A19 - &