Rolled Dielectric Elastomer Antagonistic Actuators for Biomimetic Underwater Robots

In this study, an antagonistic actuator using dielectric elastomer actuators (DEAs) is developed to investigate the use of rolled DEAs in underwater robots. The actuator consists of a backbone, an elastic hinge, and two rolled DEAs placed in an antagonistic fashion, allowing for the generation of bidirectional movements of the actuator tip. To prove this concept, an analytical model of the actuator is built. The experimental samples are fabricated based on the specification determined by the model. In the fabricated actuator, each rolled DEA has a diameter of 6 mm and a length of 21 mm. The whole device weighs 1.7 g. In the tested voltage range of 0-1200 V, the actuator exhibits a voltage-controllable angle and torque of up to 2.2 degrees and 11.3 mN center dot mm, respectively. The actuator is then implemented into a swimming robot, which shows forward speed of 0.9 mm/s at the applied voltage of 1000 V and the driving frequency of 10 Hz. The results demonstrate the feasibility of using rolled DEAs in underwater robots.