Microstructure and mechanical properties of 600 MPa grade ultra-high strength aluminum alloy fabricated by wire-arc additive manufacturing

The utilization of wire-arc additive manufacturing (WAAM) technology for the preparation of Al-Zn-Mg-Cu aluminum alloy has made some progress in recent years. However, the challenge still remains to achieve ultra-high strength (600 MPa) in WAAM. In this study, the crack-free Al-Zn-Mg-Cu-Sc thin-wall component with ultra-high strength was successfully fabricated by the cold metal transfer (CMT) pro -cess using a self-prepared 7B55-Sc filler wire. The microstructures of both as-deposited and T6 heat-treated samples were all composed of fine equiaxed grains with an average size of about 6.0 mu m. The primary Al3(Sc, Zr) particles acted as heterogeneous nuclei to promote the formation of equiaxed grains and refine the microstructures during the solidification process. A large amount of continuous eutectic structures rich in Al, Zn, Mg, and Cu elements formed along the grain boundaries under the as-deposited condition, and the precipitated second phases within the grains mainly included the equilibrium eta phase, metastable eta' phase and large-sized T phase. After T6 heat treatment, the majority of the second phases originally distributed within grains and along grain boundaries were dissolved into the Al matrix, and a large amount of fine GP zones, eta' phase and secondary Al3(Sc,Zr) particles were precipitated within the grains during the aging process. The tensile strength reached a recorded level of 618 MPa in the hori-zontal direction after T6 heat treatment, which was considered a breakthrough for the manufacturing of 600 MPa grade aluminum alloy by WAAM.(c) 2023 Published by Elsevier Ltd on behalf of The editorial office of Journal of Materials Science & Technology.