RESEARCH OF SUPERSONIC FLOW IN SHORTENED NOZZLES OF ROCKET ENGINES WITH A BELL-SHAPED TIP

被引:3
|
作者
Pryadko, N. S. [1 ,2 ]
Strelnikov, H. O. [1 ,2 ]
V. Ternova, K. [1 ,2 ]
机构
[1] Natl Acad Sci Ukraine, Inst Tech Mech, 15,Leshko Popel Str, UA-49005 Dnipro, Ukraine
[2] State Space Agcy Ukraine, 15 Leshko Popelia Str, UA-49005 Dnipro, Ukraine
关键词
shortened nozzle; tip; supersonic flow; pressure; wave structure; impulse; TRANSITION;
D O I
10.15407/knit2024.01.003
中图分类号
P1 [天文学];
学科分类号
0704 ;
摘要
The flow in a shortened nozzle with a bell-shaped tip is considered. A comparison of the wave structures of the supersonic gas flow in shortened nozzles with short and long tips formed by compression and stretching of the original bell-shaped nozzle for connection, respectively, with the long and short conical part of the base nozzle at the same nozzle length was carried out. Under operation conditions at sea level and low pressure at the nozzle inlet (P-0< 50 center dot 10(5) Pa), a large-scale vortex structure, starting from the corner point of the nozzle inlet, is observed in both nozzles. In addition, in the long tip, a small-scale vortex is observed on the wall near its cut. A barrel-shaped wave structure of hanging jumps with a closing Mach disc is formed in the flow in both nozzles, inside which a "saddle-shaped" wave structure of low intensity is noticed. In the separation flow in the tip (when P-0< 50 center dot 10(5) Pa and P-H = 1 center dot 10(5) Pa), the pressure on the wall in the separation zone is slightly lower (by approximate to 5-10%) than the external pressure P-H. When the engine is operating in the upper layers of the atmosphere, the static pressure on the section of both tips is proportional to the pressure at the entrance of the nozzle. In the cross-section, starting from the axis of the nozzle to similar to 0.89 R/R-a (the ratio of the current value of the radius R to the radius of the nozzle wall at the outlet R-a), the pressure decreases to a value proportional to the pressure at the nozzle inlet. Then, it increases linearly to the value of the pressure on the tip wall, which is proportional to the pressure at the nozzle inlet. This is due to the wave structure of the flow inside the nozzle. It was established that with a decrease in the length of the nozzle conical part, the impulse coefficient of the nozzle decreases significantly for operating at sea level and slightly decreases for operating in the upper layers of the atmosphere. The results of calculations correlate satisfactorily with the experimental study results of the flows in shortened nozzles with a bell-shaped tip.
引用
收藏
页码:3 / 13
页数:11
相关论文
共 20 条
  • [1] THE INFLUENCE OF THE ANGLE OF ENTRY INTO THE BELL-SHAPED TIP OF A SHORTENED ROUND SUPERSONIC NOZZLE OF A ROCKET ENGINE ON ITS IMPULSE CHARACTERISTICS
    Pryadko, N. S.
    Strelnikov, G. O.
    V. Ternova, K.
    SPACE SCIENCE AND TECHNOLOGY-KOSMICNA NAUKA I TEHNOLOGIA, 2024, 30 (03): : 53 - 60
  • [2] Numerical Studies of Supersonic Flow in Bell-Shaped Micronozzles
    Louisos, William F.
    Hitt, Darren L.
    JOURNAL OF SPACECRAFT AND ROCKETS, 2014, 51 (02) : 491 - 500
  • [3] Experimental investigation of the effect of bell-shaped nozzles on the two-phase pulse detonation rocket engine performance
    Yan, Yu.
    Fan, W.
    Wang, K.
    Mu, Ya.
    COMBUSTION EXPLOSION AND SHOCK WAVES, 2011, 47 (03) : 335 - 342
  • [4] Experimental investigation of the effect of bell-shaped nozzles on the two-phase pulse detonation rocket engine performance
    Yu. Yan
    W. Fan
    K. Wang
    Ya. Mu
    Combustion, Explosion, and Shock Waves, 2011, 47 : 335 - 342
  • [5] STRATIFIED FLOW PAST A BELL-SHAPED HILL
    SUZUKI, M
    KUWAHARA, K
    FLUID DYNAMICS RESEARCH, 1992, 9 (1-3) : 1 - 18
  • [6] Stratified flow over asymmetric and double bell-shaped obstacles
    Gyüre, B
    Jánosi, IM
    DYNAMICS OF ATMOSPHERES AND OCEANS, 2003, 37 (02) : 155 - 170
  • [7] Research on the Signal Process of a Bell-Shaped Vibratory Angular Rate Gyro
    Su, Zhong
    Liu, Ning
    Li, Qing
    Fu, Mengyin
    Liu, Hong
    Fan, Junfang
    SENSORS, 2014, 14 (03) : 5254 - 5277
  • [8] Numerical study of fluid flow through double bell-shaped constrictions in a tube
    Lee, TS
    INTERNATIONAL JOURNAL OF NUMERICAL METHODS FOR HEAT & FLUID FLOW, 2002, 12 (2-3) : 258 - 289
  • [9] Numerical Investigation of Flow Transition Behavior in Cold Flow Dual-Bell Rocket Nozzles
    Schneider, Dirk
    Genin, Chloe
    JOURNAL OF PROPULSION AND POWER, 2016, 32 (05) : 1212 - 1219
  • [10] Research on Bell-Shaped Vibratory Angular Rate Gyro's Character of Resonator
    Su, Zhong
    Fu, Mengyin
    Li, Qing
    Liu, Ning
    Liu, Hong
    SENSORS, 2013, 13 (04): : 4724 - 4741