Application of electro oxidation process for treating wastewater from petrochemical with mixed metal oxide electrode

Petrochemicals require a large volume of water for their operation, which results in the production of a large volume of wastewater. Treatment of petrochemical wastewater is an important process before discharging it into the environment. This research examines the treatment of real petrochemical wastewater using the electrochemical oxidation process. Direct anodic oxidation is an effective advanced electrochemical oxidation process (AEOP), with different electrodes using a parallel plate electrochemical reactor. Four types of real wastewater were received from different petrochemical units were treated by AEOP. Real wastewater samples with chemical oxygen demand (COD) concentrations ranging from 20,450 to 52,300 mg/l. The main goal of this research is to make electrodes of Mixed Metal Oxide (MMO), which can reduce the treatment time and electricity consumption for oxidation, greater stability of the surface of the electrodes. Investigation of the rate constant kinetics shows that high COD removal efficiency can be achieved following the pseudo-second order reaction rate (R-2 > 98%). When the wastewater pH is less than 5, COD removal efficiency is higher and the treatment process will be successful, which succeeded in removing 79% COD, but in alkaline wastewater, COD reduction efficiency was not satisfactory. The electricity consumption for 79% removal during 6 min was 117 kWh/m(3). As a result, due to the very short time of the process (6 min), it can be used as one of the pre-treatment steps of petrochemical wastewater with acidic pH.