Effect of Choice of Drilling Kinematic System on Cylindricity Deviation, Roundness Deviation, Diameter Error and Surface Roughness of Holes in Brass Alloy

被引:0
|
作者
Bronis, Mateusz [1 ]
Krawczyk, Bartlomiej [2 ,3 ]
Legutko, Stanislaw [2 ]
机构
[1] Kielce Univ Technol, Dept Machine Design & Machining, Al Tysiaclec Panstwa Polskiego 7, PL-25314 Kielce, Poland
[2] Poznan Univ Tech, Fac Mech Engn, Piotrowo 3, PL-60965 Poznan, Poland
[3] Pratt & Whitney Kalisz, Elektryczna 4a, PL-62800 Kalisz, Poland
关键词
drilling; kinematic system; hole quality; surface texture; brass alloy; ANOVA; Grey Relational Analysis; LEAD; MACHINABILITY; OPTIMIZATION;
D O I
10.3390/pr12010220
中图分类号
TQ [化学工业];
学科分类号
0817 ;
摘要
This article presents the results of an experimental study on the effect of the selection of kinematic system for the drilling process on the cylindricity deviation, roundness deviation, diameter error and surface roughness of holes in brass alloy. Three different kinematic systems based on the dependence of the direction of rotation of the workpiece and the drill bit were used. The drill bit was mounted in an axially driven holder that allowed it to be put into motion. Cutting tests were conducted at three different spindle speeds and three different feed rates per revolution (27 tests in total). A static ANOVA analysis was used to evaluate the effect of each input parameter on each output parameter. The results of this work have practical applications in machining. The following input parameters of the drilling process should be used to obtain the smallest values of each output parameter: for CYL, n = 4775 rpm, fn = 0.14 mm/rev and KIN III; for RON, n = 4775 rpm, fn = 0.1 or 0.12 mm/rev and KIN II; for DE, n = 3979 rpm, fn = 0.1 mm/rev and KIN I; and for Rz, n = 4775 rpm, fn = 0.1 mm/rev and KIN II. This research work also used Grey Relational Analysis with which input parameter optimization was derived. The optimal drilling parameters are spindle speeds of 4775 rpm, a feed per revolution of 0.1 mm/rev and the use of the first kinematic system. This paper also includes equations for predicting each parameter that describes the dimensional and shape accuracy and roughness of the hole surface. Using the first kinematic system reduced the roughness of the hole surface by as much as 58%. The correct selection of kinematic system improved its dimensional accuracy by 15%. On the other hand, the roundness deviation of the hole improved by 33% and the cylindricity deviation of the hole by 6%.
引用
收藏
页数:18
相关论文
共 2 条
  • [1] Evaluation and Multi-Criteria Optimization of Surface Roughness, Deviation From Dimensional Accuracy and Roundness Error in Drilling CFRP/Ti6Al4 Stacks
    Motorcu, Ali Riza
    Ekici, Ergun
    FME TRANSACTIONS, 2022, 50 (03): : 441 - 460
  • [2] Experimental Study on optimizing the effect of drilling parameters on roundness error of holes of Aluminum 7075 using Response Surface Methodology
    Zargar, S. H.
    Tahmasbi, V.
    Besharati, K.
    Farzami, M.
    FRONTIERS OF MECHANICAL ENGINEERING AND MATERIALS ENGINEERING, PTS 1 AND 2, 2012, 184-185 : 981 - +