Effect of Crosslink Density on Thermal Aging of Bio-Based Rigid Low-Density Closed-Cell Polyurethane Foams

被引：2

作者：

Kirpluks, M. ^{[1
]}

Godina, D. ^{[1
]}

Svajdlenkova, H. ^{[2
,3
]}

Sausa, O. ^{[3
,4
]}

Modniks, J. ^{[1
,5
]}

Simakovs, K. ^{[1
]}

Andersons, J. ^{[1
,5
]}

机构：

[1] Latvian State Inst Wood Chem, Polymer Lab, LV-1006 Riga, Latvia

[2] Slovak Acad Sci, Polymer Inst, Bratislava 84541, Slovakia

[3] Comenius Univ, Dept Nucl Chem, Bratislava 84215, Slovakia

[4] Inst Phys, Slovak Acad Sci, Bratislava 84511, Slovakia

[5] Univ Latvia, Inst Mech Mat, LV-1004 Riga, Latvia

来源：

ACS APPLIED POLYMER MATERIALS | 2023年 / 5卷 / 06期

关键词：

polyurethane; rigid low-density foams; thermalaging; gas diffusivity; free volume; ANNIHILATION LIFETIME SPECTROSCOPY; MECHANICAL-PROPERTIES; INSULATION MATERIALS; BLOWING AGENTS; HEAT-TRANSFER; FREE-VOLUME; CONDUCTIVITY; PERMEABILITY; TEMPERATURE; MIXTURES;

D O I：

10.1021/acsapm.3c00470

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

Gradual replacement of the traditional raw materialsin polyurethane(PU) synthesis by bio-based ones and introduction of environmentallyfriendly physical blowing agents (PBAs) motivate the analysis of thermalaging of bio-based foams in order to optimize the chemical structureof the PU matrix so that its permeability to PBA is minimized. Withthe aim of elucidating the effect of the PU chemical structure onthermal aging of foams, rigid low-density closed-cell PU foams wereproduced solely from bio-based polyols. The effective diffusivitiesof PBA and atmospheric gasses were evaluated based on the measuredthermal conductivity aging of foams and validated by gas chromatographymeasurements of gas composition in foam cells. Gas permeability ofthe PU polymer was estimated based on effective diffusivity in foamsand foam morphology and found to decrease with increasing crosslinkdensity, apparently due to reduction in the fractional free volumein the polymers.

引用

页码：4305 / 4315

页数：11

共 50 条

[1] Anisotropic thermal expansion of bio-based rigid low-density closed-cell polyurethane foams
Andersons, J.
Grube, R.
Vevere, L.
Cabulis, P.
Kirpluks, M.
JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T, 2022, 16 : 1517 - 1525
[2] Modelling the effect of morphology on thermal aging of low-density closed-cell PU foams
Kirpluks, M.
Andersons, J.
Modniks, J.
INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER, 2022, 139
[3] Estimation of the effective diffusivity of blowing agents in closed-cell low-density polyurethane foams based on thermal aging data
Andersons, J.
Modniks, J.
Kirpluks, M.
JOURNAL OF BUILDING ENGINEERING, 2021, 44
[4] The Effect of Crosslink Density on the Physical and Mechanical Properties of Bio-Based Polyurethane Foams
Andersons, Janis
Cabulis, Peteris
Kirpluks, Mikelis
MACROMOLECULAR SYMPOSIA, 2022, 404 (01)
[5] Anisotropy of the stiffness and strength of rigid low-density closed-cell polyisocyanurate foams
Andersons, J.
Kirpluks, M.
Stiebra, L.
Cabulis, U.
MATERIALS & DESIGN, 2016, 92 : 836 - 845
[6] A comprehensive research of low-density bio-based rigid polyurethane foams from sugar beet pulp-based biopolyol: From closed-cell towards open-cell structure
Akdogan, Emre
Erdem, Murat
INDUSTRIAL CROPS AND PRODUCTS, 2023, 200
[7] Bio-based rigid high-density polyurethane foams as a structural thermal break material
Andersons, J.
Kirpluks, M.
Cabulis, P.
Kalnins, K.
Cabulis, U.
CONSTRUCTION AND BUILDING MATERIALS, 2020, 260
[8] Lignin-Based Low-Density Rigid Polyurethane/Polyisocyanurate Foams
Henry, Christian
Nejad, Mojgan
INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH, 2023, 62 (18) : 6865 - 6873
[9] Design of polypropylene resins for fabrication of low-density, closed-cell strand foams
Sammler, Robert
ABSTRACTS OF PAPERS OF THE AMERICAN CHEMICAL SOCIETY, 2016, 251
[10] Deformation mechanisms and the yield surface of low-density, closed-cell polymer foams
N. J. Mills
Journal of Materials Science, 2010, 45 : 5831 - 5843

← 1 2 3 4 5 →