Analysis and control of products obtained from pyrolysis of polypropylene using a reflux semi-batch reactor and GC-MS/FID and FT-ICR MS

Pyrolysis of plastic waste allows to produce liquid fractions, but their molecular weight distributions are typically very large whereas it would be interesting to focus on light hydrocarbons. In this study, the pyrolysis of polypropylene (PP) was investigated using a semi-batch, vertical glass reactor heated at 480 degrees C equipped with a reflux condenser. The pyrolysis was performed with and without a reflux condenser. The temperature at the top of this reflux condenser was ranged from 125 degrees C to 200 degrees C depending on the heating power at the wall of this condenser. The permanent gas yield (C1 to C4) ranged between 20.9 wt% and 25.8 wt% when the reflux was used. The gas contained mainly hydrocarbons with a carbon range from C1 to C4 and H2 in a smaller extent. Their kinetic profiles followed a similar trend, i.e they exhibited a maximum with time. The GC-MS/FID detected mainly olefinic hydrocarbons (olefins) with less than 28 carbons. The major hydrocarbons obtained were light and heavy naphtha cuts when the reflux was used. The range of light naphtha (C5-C7) was between 13.1 and 16.7 wt% and the range of heavy naphtha (C8-C12) was between 69.1 and 87.2 wt% of the total mass fraction detected. The experiments demonstrated that the presence of the reflux has a significant impact on the liquid and gas yields. It allows to narrow the molecular weight distribution range of the liquid, which was confirmed by FT-ICR MS. As a consequence, the molecules of interest are maximised, especially those corresponding to the naphtha cuts.