Simulation of jets induced by steam injection through multi-hole sparger using effective heat and momentum models

Direct contact condensation (DCC) of steam in the pressure suppression pool (PSP) is used to control containment pressure in Boiling Water Reactors (BWRs) and Advanced Pressurized Water Reactors (APWRs). The competition between momentum and heat sources induced by steam injection through multi-hole spargers and blowdown pipes determines whether the pool is thermally stratified or mixed. Development of thermal stratification affects capacity of the PSP to condense steam. To enable computationally efficient modeling of the PSP transients, the Effective Heat Source (EHS) and Effective Momentum Source (EMS) models have been proposed previously. The EHS/EMS models enable simulation of the large scale pool behavior without explicit modeling of the steam water interface and DCC phenomena. One of the problems for an optimal implementation of the EHS/EMS models is the definition of the boundary conditions that impose distribution of the momentum and heat sources. In this work, EHS/EMS models are implemented using "Unit Cell" approach in ANSYS Fluent to provide detailed nu-merical analysis of the individual turbulent jets induced by steam injection through the sparger holes. The model is validated against data from Particle Image Velocimetry (PIV) and temperature measurements for a range of steam injection conditions in the PANDA HP5 tests. Good agreement between the test data and simulations suggests that the proposed model can provide sufficiently accurate prediction of both local and large scale phenomena induced by steam injection into the pool.