The Effect of Different Magnetic Separation Procedures of a Korean VTM Ore on Combined Pyro-hydrometallurgical Vanadium Recovery Behavior

被引:1
|
作者
Kim, Rina [1 ,2 ]
Eom, Yuik [3 ]
Ahn, Yeongjin [1 ]
Chung, Kyeong Woo [1 ,2 ]
Lee, Sujeong [1 ,2 ]
Kim, Min-seuk [1 ]
Go, Byunghun [1 ]
Kim, Hong-In [1 ,2 ]
Jeon, Ho-Seok [1 ,2 ]
机构
[1] Korea Inst Geosci & Mineral Resources, Resources Utilizat Div, Daejeon, South Korea
[2] Univ Sci & Technol, Resources Engn, Daejeon, South Korea
[3] Curtin Univ, Western Australian Sch Mines Minerals Energy & Che, Kalgoorlie, Australia
关键词
Vanadium; VTM; Magnetic separation; Salt roasting; Water leaching; FLY-ASH; EXTRACTION; CHROMIUM; OPTIMIZATION; DISSOLUTION; SLAG;
D O I
10.1007/s42461-024-00943-1
中图分类号
TF [冶金工业];
学科分类号
0806 ;
摘要
The study focused on the recovery of vanadium from a Korean vanadium-bearing titaniferous magnetite (VTM) ore, examining the behaviors of magnetic separation and Na2CO3 roasting-water leaching. Two concentrates were prepared using single-stage dry magnetic separation and three-step wet magnetic separation, resulting in V2O5 grades of 0.8% and 1.0% and major gangue mineral SiO2 contents of 6.5% and 1.7%, respectively. These concentrates were subsequently roasted at 1050 degrees C with the addition of Na2CO3 and then water-leached at 25 degrees C. Various stoichiometric ratios of V2O5 to Na2CO3 were tested, ranging from 1:1 to 1:40 of the theoretically required amount. As the amount of Na2CO3 increased, the vanadium leaching efficiency showed fluctuations between 4 and 35% for ratios of 1:1 to 1:10, while it linearly increased from 4 to 82% for ratios of 1:10 to 1:40 in the leaching of the low-grade concentrate. In contrast, the leaching efficiency increased from 47 to 74% for ratios of 1:1 to 1:8 and then sharply rose to 84% at a ratio of 1:10 in the leaching of the high-grade concentrate. Subsequently, it reached a plateau of 92 to 94% for ratios of 1:20 to 1:40. The difference in leaching efficiency was primarily due to the reaction of gangue minerals with Na2CO3, which hindered vanadium leaching from the VTM concentrates. This hindrance was notably more pronounced in the low-grade concentrate with the lower salt ratio, as the gangue minerals exhibited a preference for consuming Na2CO3 over vanadium. The mineral formation was analyzed in detail using XRD and MLA to shed light on the mechanism of different vanadium leaching behavior depending on the concentrate grade and vanadium to salt ratio. Based on the results of this study, it is evident that applying a proper magnetic separation procedure is significant to achieving satisfactory vanadium recovery with less salt amount by removing gangue minerals ahead.
引用
收藏
页码:547 / 558
页数:12
相关论文
共 2 条
  • [1] The Effect of Different Magnetic Separation Procedures of a Korean VTM Ore on Combined Pyro-hydrometallurgical Vanadium Recovery Behavior
    Rina Kim
    Yuik Eom
    Yeongjin Ahn
    Kyeong Woo Chung
    Sujeong Lee
    Min-seuk Kim
    Byunghun Go
    Hong-In Kim
    Ho-Seok Jeon
    Mining, Metallurgy & Exploration, 2024, 41 : 547 - 558
  • [2] Optimized magnetic separation for efficient recovery of V and Ti enriched concentrates from vanadium-titanium magnetite ore: Effect of grinding and magnetic intensity
    Han, Yosep
    Kim, Seongmin
    Go, Byunghun
    Lee, Sujeong
    Park, Seongkyun
    Jeon, Ho-Seok
    POWDER TECHNOLOGY, 2021, 391 (391) : 282 - 291