Analysis of the mechanical behavior and prediction of the plastic zone of a large-diameter buried gas pipeline under ground overload

Plastic failure of pipelines caused by ground overload is increasing. The one-dimensional model based on mechanical nodal parameters cannot predict the plastic failure characteristics of the three-dimensional structure of the pipeline. In order to predict the evolution of the plastic failure of the pipeline with the yield strength as the evaluation criterion, a multidimensional model is needed to consider the changes in the external loads and the changes in the mechanical properties of the pipeline along the circumferential and axial directions. In this study, a finite element calculation model for a large-diameter gas pipeline underground overload was established to investigate the law of stress change in the plastic zone. The nonlinear surface fitting method was used to establish the angle fitting model of the plastic zone and the depth fitting model of the plastic zone. The variation of the area of the plastic zone was described, and the reliability of the results was verified. In addition, the accuracy of the fitting model and the cost of the finite element calculation were evaluated. The results showed that the pipeline entered plasticity at a ground load of P = 25 MPa, and the plastic zone developed continuously in the axial and circumferential directions as the ground load increased. The angle and depth increased to 36 degrees and 1.8 m, respectively, at P = 50 MPa. The average absolute errors for the plastic zone depth fitting model and the plastic zone angle fitting model were 6.42% and 6.64%, respectively, both of which can provide an accurate description of the plastic zone. The calculation results of the plastic zone angle fitting model could meet requirements of data processing and analysis. The plastic zone depth fitting model could be used to obtain solutions with higher accuracy, but it increases the cost of finite element simulation.