Development of a Numerical Simulation Methodology for PCM-Air Heat Exchangers Used in Decentralised Facade Ventilation Units

This paper presents the development of a methodology for using simulation to test decentralised facade ventilation systems with PCM exchangers and its validation with experimental data. Two approaches were compared to simulate the operation of an exchanger filled with phase-change material. In Method A, the geometry consisted of an air domain and a phase-change material domain, located in the cylinders of the exchanger. In this method, the phase transition was not modelled, but the specific heat was made temperature-dependent, wherein within the limits of the melting point, the specific heat is increased to a level that mimics the amount of latent heat from melting and solidification of the phase-change material. In Method B, the geometry consisted only of the air domain, and the temperature was set on the cylinder wall surfaces at each time step using UDFs. When comparing the methods, the temperature difference at the individual measuring points was no greater than 1 K and the resulting exchanger efficiencies did not differ by more than 5%. It was noted that when the phase-change material was modelled in the software with Method A, the results provided better representation of the values obtained in the experiment. Validation of the models was carried out by comparing the experimental results from the real tests with the simulation results of methods A and B. It demonstrated that both models correctly reflected the operation of the exchanger, and that the efficiency results achieved did not differ by more than 6% compared to the experiment. A comparison of supply temperatures and exchanger efficiencies with numerical simulations using two methods is presented. Visual comparison of the temperature distribution in the flowing air and the temperature distribution on the cylinder walls is also presented. This article adds to existing scientific knowledge of computer simulation of exchangers used in facade ventilation units with phase-change material.