Influence of the cutting method on the fatigue life and crack initiation of non-oriented electrical steel sheets

The fatigue behavior of thin electrical steel sheets under cyclic loading is investigated in dependence on the edge surface. Therefore, four different edge conditions are compared, whereas the edge is either laser cut, shear cut, wire cut, or polished. Strain- and stress-controlled fatigue tests are performed to determine S-N curves in the low cycle regime as well as in the high cycle regime. Microstructural data is collected by non-contacting (optical) Profilometry, Nanoindentation, X-Ray Diffraction, and Electron Backscatter Diffraction to understand the differences in fatigue life by considering surface roughness, residual stresses, hardness, and microstructure. Shear cut specimens achieve the lowest fatigue life, while the other edge conditions reach relatively similar values in the LCF regime. Crack initiation is mainly intergranular in the case of defect-free edges. This tendency has a considerable influence on the observed fatigue behavior.