The Fate of Heavy Metals and Risk Assessment of Heavy Metal in Pyrolysis Coupling with AcidWashing Treatment for Sewage Sludge

Pyrolysis is an emerging and effective means for sludge disposal. Biochar derived from sludge has broad application prospects, however, is limited by heavy metals. In this study, the fate of heavy metals (HMs) in pyrolysis coupling with acid washing treatment for sewage sludge was comprehensively investigated for the first time. Most of the HMs redistributed in the pyrolyzed residues (biochar) after pyrolysis, and the enrichment order of the HMs was: Zn > Cu > Ni > Cr. Compared with various washing agents, phosphoric acid presented a superior washing effect on most heavy metals (Cu, Zn, and Cr) in biochars derived at low pyrolysis temperature and Ni in biochars derived at high pyrolysis temperature. The optimal washing conditions for heavy metals (including Cu, Zn, Cr, and Ni) removal by H3PO4 were obtained by batch washing experiments and the response surface methodology (RSM). The total maximum HM removal efficiency was 95.05% under the optimal washing specifications by H3PO4 (acid concentration of 2.47 mol/L, L/S of 9.85 mL/g, and a washing temperature of 71.18 degrees C). Kinetic results indicated that the washing process of heavy metals in sludge and biochars was controlled by a mixture of diffusion and surface chemical reactions. After phosphoric acid washing, the leaching concentrations of HMs in the solid residue were further reduced compared with that of biochar, which were below the USEPA limit value (5 mg/L). The solid residue after pyrolysis coupling with acid washing resulted in a low environmental risk for resource utilization (the values of the potential ecological risk index were lower than 20). This work provides an environmentally friendly alternative of pyrolysis coupling with acid washing treatment for sewage sludge from the viewpoint of the utilization of solid waste.