Modeling the effects of constructed wetland on nonpoint source pollution control and reservoir water quality improvement

This article describes the integrated modeling approach for planning the size and the operation of constructed wetlands for maximizing retention of nonpoint source pollutant loads and reservoir water-quality improvement at a catchment scale.The experimental field-scale wetland systems (four sets,0.88 ha each) have been in operation since 2002,where water depth was maintained at 30–50 cm and hydraulic loading rate was at 6.3–18.8 cm/day.The wetland system was found to be adequate for treating polluted stream water with stable removal efficiency even during the winter.The integrated modeling system (modified-BASINS) was applied to the Seokmoon estuarine reservoir watershed and calibrated with monitoring data from constructed wetland,stream,and reservoir.The calibrated integrated modeling system estimated that constructing wetlands on 0.5% (about 114 ha) of the watershed area at the mouth of reservoir could reduce 11.61% and 13.49% of total external nitrogen and phosphorus loads,respectively.It also might improve the nitrogen and phosphorus concentration of the reservoir by 9.69% and 16.48%,respectively.The study suggested that about 0.1%–1.0% of the watershed area should be allocated for constructed wetland to meet specified water-quality standards for the estuarine reservoir at the polder area where land use planning is relatively less complicated.