Effects of Y and Zn on mechanical properties and damping capacity of Mg-Cu-Mn alloy

被引：0

作者：

王敬丰 ^{[1
,2
]}

魏文文 ^{[1
,2
]}

李龙 ^{[2
]}

梁浩 ^{[1
,3
]}

潘复生 ^{[1
]}

机构：

[1] National Engineering Research Center for Magnesium Alloys,Chongqing University

[2] College of Materials Science and Engineering,Chongqing University

[3] Institute of System Engineering,China Academy of Engineering Physics

来源：

TransactionsofNonferrousMetalsSocietyofChina | 2010年 / 20卷 / 10期

基金：

中国国家自然科学基金;

关键词：

Mg-Cu-Mn alloy; Y; Zn; magnesium alloys; damping capacity; Granato-Lücke theory;

D O I：

暂无

中图分类号：

TG146.22 [];

学科分类号：

摘要：

Optical microscope,X-ray diffractometer,scanning electron microscope,tensile tester and dynamic mechanical analyzer(DMA) were applied to investigate the effects of Y and Zn additions on microstructure,mechanical properties and damping capacity of Mg-3Cu-1Mn(CM31) alloy.The results show that with the increase of Y and Zn contents,the secondary dendrite arm spacing of alloys is reduced;meanwhile,the yield strength is increased.In low strain amplitude,the damping capacity of alloys with Y and Zn addition is lower than that of CM31 alloy.However,in strain amplitude over 5×10-3,the damping capacity of alloy with a trace of Y and Zn addition(1%Y and 2%Zn,mass fraction) increases abnormally with the increase of strain amplitude and is near to that of pure Mg,probably due to the increase of dislocation density caused by the precipitation of secondary phase.The temperature dependence of damping capacity of above alloy was also tested and discussed.

引用

页码：1846 / 1850

页数：5

共 50 条

[1] Effects of Y and Zn on mechanical properties and damping capacity of Mg-Cu-Mn alloy
Wang Jing-feng
Wei Wen-wen
Li Long
Liang Hao
Pan Fu-sheng
TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA, 2010, 20 (10) : 1846 - 1850
[2] Effects of Cu and Mn on mechanical properties and damping capacity of Mg-Cu-Mn alloy
章桢彦
彭立明
曾小勤
丁文江
Transactions of Nonferrous Metals Society of China, 2008, 18(S1) (S1) : 55 - 58
[3] Effects of Cu and Mn on mechanical properties and damping capacity of Mg-Cu-Mn alloy
Zhang Zhen-yan
Peng Li-ming
Zeng Xiao-qin
Ding Wen-Jiang
TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA, 2008, 18 : S55 - S58
[4] Effects of Cu and Mn on mechanical properties and damping capacity of Mg-Cu-Mn alloy
National Engineering Research Center of Light Alloy Net Forming, Shanghai Jiao Tong University, Shanghai 200240, China
不详
Trans Nonferrous Met Soc China, 2008, SPEC. ISSUE 1 (s55-s58):
[5] Damping properties of a sintered Mg-Cu-Mn alloy
Nishiyama, K
Matsui, R
Ikeda, Y
Niwa, S
Sakaguchi, T
JOURNAL OF ALLOYS AND COMPOUNDS, 2003, 355 (1-2) : 22 - 25
[6] Damping behavior and mechanical properties of Mg-Cu-Mn alloy processed by equal channel angular pressing
Zheng Ming-yi
Fan Guo-dong
Tong Li-bo
Hu Xiao-shi
Wu Kun
TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA, 2008, 18 : S33 - S38
[7] Damping behavior and mechanical properties of Mg-Cu-Mn alloy processed by equal channel angular pressing
Zheng, Ming-Yi
Fan, Guo-Dong
Tong, Li-Bo
Hu, Xiao-Shi
Wu, Kun
Transactions of Nonferrous Metals Society of China (English Edition), 2008, 18 (SPEC. ISSUE 1):
[8] Damping behavior and mechanical properties of Mg-Cu-Mn alloy processed by equal channel angular pressing
郑明毅
范国栋
佟立波
胡小石
吴昆
TransactionsofNonferrousMetalsSocietyofChina, 2008, 18(S1) (S1) : 33 - 38
[9] Preparation and properties of Mg-Cu-Mn-Zn-Y damping magnesium alloy
Wang, Jingfeng
Wei, Wenwen
Huang, Xuefei
Li, Long
Pan, Fusheng
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2011, 528 (21): : 6484 - 6488
[10] Effects of extrusion on the mechanical properties and damping capacity of Mg-1.8Cu-0.5Mn alloy
Zhang, Zhenyan
Peng, Liming
Zeng, Xiaoqin
Du, Lin
Ma, Lan
Ding, Wenjiang
2006 BIMW: 2006 BEIJING INTERNATIONAL MATERIALS WEEK, PTS 1-4: MAGNESIUM, 2007, 546-549 : 257 - +

← 1 2 3 4 5 →