Influence of Strain Rate on Tensile Characteristics of SUS304 Metastable Austenitic Stainless Steel

The microstructure characteristics and plastic deformation behavior of SUS304 metastable austenitic stainless steel sheets have been investigated during tensile process at diferent strain rates at room temperature.The yield stress continuously increases with strain rates due to low fraction of martensite transformed from austenite at 0.2%plastic stain.While the ultimate tensile stress(UTS)and elongation gradually decreases and then slightly increases with increase in strain rate from 0.0005 s 1to 0.1 s 1,which is attributed to the variation of the martensite fraction that is afected seriously by adiabatic heating.A higher temperature increase in the tensile specimens restricts the martensitic transformation at high strain rate.The strain rate of 0.1 s 1is considered as a transition deformation rate from quasi-static state to plastic forming,where the transformed martensitic content is very small in a higher strain rate range.Anomalous stress peaks in the later half stage of deformation occur at a very low strain rate(i.e.,0.0005 s 1)result from X-shaped strain localization repeatedly sweeping over the specimen.With increasing strain rates,the variation of dimple number density follows similar trend as that of UTS and ductility because martensite fraction mostly influences void nucleation and growth.