Optimizing laser cladding process parameters for transformation-induced plasticity FeMnCoCr high entropy alloy: A multi-objective approach

A multi-objective optimization approach utilizing the response surface method (RSM) is proposed to determine the optimal processing parameters for laser cladding of Fe50Mn30Co10Cr10 coating. In this paper, a single-variable control method was employed to adjust the laser cladding parameters, and preliminary experiments were conducted to establish the optimization range for the RSM laser cladding parameters. A mathematical prediction model of input processing parameters (laser power, scanning speed and powder feed speed) and output response (dilution rate, W/H, microhardness and porosity) was established by the response surface method. The results indicated that both the dilution rate and microhardness had a positive correlation with laser power and scanning speed, while they were negatively correlated with the powder feed rate. The scanning speed is the most significant factor influencing the porosity of the coating, followed by the powder feed rate. The optimal processing parameters were identified as follows: laser power at 1750 W, scanning speed at 8.0 mm/s, and powder feed rate at 11.5 g/min. The model demonstrated strong agreement with the experimental results. The coating molding quality is exceptional, with an average porosity of 0.07 % and an average microhardness of 208.32 HV0.2. Meanwhile, the coating was composed of HCP phase and FCC phase, with the HCP phase comprising15.6 % and the FCC phase 84.4 %, respectively. Under the optimal processing parameters, the Fe50Mn30Co10Cr10 highentropy alloy coating demonstrated impressive ductility and strength, with a deformation of 55.93 % and a compressive strength of 2153.7 MPa. The fracture mechanism of Fe50Mn30Co10Cr10 coatings is transcrystalline fracture and toughness fractures.