Analysis of vibration characteristics of inter-shaft bearing with local defects based on multi-body dynamics

被引:0
|
作者
Tian, Jing [1 ]
Ai, Xinping [1 ]
Zhang, Fengling [1 ]
Wang, Zhi [1 ]
Wang, Cai [1 ]
机构
[1] Liaoning Key Laboratory of Advanced Measurement and Test Technology for Aviation Propulsion System, School of Aero-engine, Shenyang Aerospace University, Shenyang,110136, China
来源
关键词
Residual stresses;
D O I
10.13224/j.cnki.jasp.20220521
中图分类号
学科分类号
摘要
In order to study the vibration characteristics and contact stress of an inter-shaft bearing with local defects,a two-dimensional fully flexible dynamic model of the inter-shaft bearing with single and compound faults was established based on the multi-body dynamics method. With this model,the time-frequency distribution characteristics and contact stress variation law of the inter-shaft bearing with local defects were analyzed. Compared with the lumped parameter model based on nonlinear Hertz contact theory and the experimental results,the accuracy of the multi-body dynamics model was verified. The research results showed that the error between the fault characteristic frequency obtained based on the established model and the lumped parameter model and the experimental results was less than 1%. The maximum value of the equivalent contact stress of the bearing appeared at the fault crack,spread around and reduced; the contact stress in the bearing area was significantly higher than that in the non bearing area,and the time interval of the change of the equivalent stress was the reciprocal of the fundamental frequency of the inter-shaft bearing fault characteristic frequency. © 2024 Beijing University of Aeronautics and Astronautics (BUAA). All rights reserved.
引用
收藏
相关论文
共 50 条
  • [1] Analysis on Dynamic Characteristics of Inter-shaft Bearing
    Wang Yan-shuang
    Sheng Pai-pai
    PROCEEDINGS OF THE 2017 7TH INTERNATIONAL CONFERENCE ON ADVANCED DESIGN AND MANUFACTURING ENGINEERING (ICADME 2017), 2017, 136 : 98 - 102
  • [2] Analysis of vibration characteristics of a dual rotor system with inter-shaft bearing waviness
    Liu, Kun-Peng
    Liu, Hong-Da
    Shi, Xiu-Jiang
    Wang, Dong-Hua
    Li, Wan-You
    Zhendong Gongcheng Xuebao/Journal of Vibration Engineering, 2024, 37 (09): : 1523 - 1534
  • [3] Dynamic Modeling and Vibration Analysis for Inter-shaft Bearing Fault
    Cao H.
    Jing X.
    Su S.
    Chen X.
    Jixie Gongcheng Xuebao/Journal of Mechanical Engineering, 2020, 56 (21): : 89 - 99
  • [4] Nonlinear vibration characteristics of a dual-rotor system with inter-shaft bearing
    Gao P.
    Hou L.
    Chen Y.
    Zhendong yu Chongji/Journal of Vibration and Shock, 2019, 38 (15): : 1 - 10
  • [5] Dynamic characteristics analysis of a dual-rotor system with inter-shaft bearing
    Wang, Nanfei
    Jiang, Dongxiang
    Xu, Hongzhi
    PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART G-JOURNAL OF AEROSPACE ENGINEERING, 2019, 233 (03) : 1147 - 1158
  • [6] Dynamic Modeling and Simulation Analysis of Inter-Shaft Bearing with Multi-Point Faults
    Tian, Jing
    Liu, Li-Li
    Zhang, Feng-Ling
    Wang, Zhi
    Ai, Yan-Ting
    Tuijin Jishu/Journal of Propulsion Technology, 2022, 43 (02): : 299 - 308
  • [7] Dynamic modeling and vibration characteristic analysis of the inter-shaft bearing’s multiple point fault
    Tian J.
    Ai X.
    Liu L.
    Zhang F.
    Wang Z.
    Zhendong yu Chongji/Journal of Vibration and Shock, 2022, 41 (22): : 144 - 151
  • [8] METHOD OF COUPLED VIBRATION CONTROL FOR DUAL ROTOR SYSTEM WITH INTER-SHAFT BEARING
    Ma, Yanhong
    Shi, Chenglong
    Sun, Bo
    Hong, Jie
    PROCEEDINGS OF ASME TURBO EXPO 2021: TURBOMACHINERY TECHNICAL CONFERENCE AND EXPOSITION, VOL 9B, 2021,
  • [9] Nonlinear thermal analysis for the inter-shaft bearing under the dynamic load
    Gao P.
    Hou L.
    Chen Y.
    Lixue Xuebao/Chinese Journal of Theoretical and Applied Mechanics, 2021, 53 (01): : 248 - 259
  • [10] Failure Analysis of an Inter-shaft Bearing of an Aero Gas Turbine Engine
    Mishra R.K.
    Muduli S.K.
    Srinivasan K.
    Ahmed S.I.
    Journal of Failure Analysis and Prevention, 2015, 15 (2) : 205 - 210