Calculation of height error of articles stamped in open dies with supports in hot-stamping crank press

被引：0

作者：

Balaganskij, V.I.

Prutskov, R.N.

Moroz, V.Ya.

机构：

来源：

Kuznechno-Shtampovochnoe Proizvodstvo (Obrabotka Metallov Davleniem) | 2001年 / 03期

关键词：

Calculations - Dies - Error analysis - Hot pressing - Metal stamping - Presses (machine tools);

D O I：

暂无

中图分类号：

学科分类号：

摘要：

There is described the method and there are presented results of calculation of height error of flat elongated workpieces stamped in open dies with supports in a hot-stamping crank press by 40 MN of rated force. In calculation, there are used previously obtained (see # 2, 2001 issue of this journal, p.3-8) initial dependences and vertical rigidity characteristics of elements of the 'press-die plates-tool insertions-supports' system. The obtained results are used when designing the open dies with supports.

引用

页码：3 / 7

共 5 条

[1] Calculation of rigidity of dies with supports for hot-stamping crank press
Balaganskij, V.I.
Prutskov, R.N.
Kuznechno-Shtampovochnoe Proizvodstvo (Obrabotka Metallov Davleniem), 2001, (02): : 3 - 8
[2] Evaluation of useful energy of stamped article plastic deformation as applied to hot-stamping crank press
2001, Mashinostroeni
[3] Optimal frequency of cross-head strokes of hot-stamping crank press
Kruk, A.T.
Kuznechno-Shtampovochnoe Proizvodstvo (Obrabotka Metallov Davleniem), 2002, (10): : 40 - 42
[4] On-line adjustment of the minimum shut height of hot-stamping crank presses
Balaganskij, V.I.
Prutskov, R.N.
Bocharov, Yu.A.
Kuznechno-Shtampovochnoe Proizvodstvo (Obrabotka Metallov Davleniem), 2003, (03): : 33 - 38
[5] Automatic processes of forged pieces manufacture with hot-stamping crank press. Part 2. Possibilities and outlooks
Fedorkevich, V.F.
Achkasov, A.T.
Kruk, A.T.
Kuznechno-Shtampovochnoe Proizvodstvo (Obrabotka Metallov Davleniem), 2001, (11): : 39 - 42

← 1 →