Basic study on relation between flatness of end of high strength concrete specimen and compressive strength

被引：0
|
作者：
Koyama Y. [1 ,2 ]
Hayakawa M. [3 ]
Jinnai H. [4 ]
Nakamura M. [2 ]
机构：
[1] Graduate School of Eng., Tokyo Polytechnic Univ.
[2] Tokyo Kensa Co., Ltd., Construction Materials Laboratory
[3] Dept. of Architecture, Faculty of Eng., Tokyo Polytechnic Univ.
[4] Technology Center, Taisei Corp.
来源：
Journal of Structural and Construction Engineering | 2010年 / 75卷 / 649期
关键词：
Compressive strength; Flatness measurement; High strength concrete; Specimen;
D O I：
10.3130/aijs.75.475
中图分类号：
TU528 [混凝土及混凝土制品]; TV43 [水工混凝土和砂浆];
学科分类号：
摘要：
In this research, the relation between the flatness of the end of the high strength concrete specimen and its compressive strength was examined The results of the examination are shown as follows. (1) The flatness of the end of the specimen can be evaluated by measuring 17 points with a device shown in JIS A 5308. (2) Flatness of the end of the specimen will change with the time passing. Therefore, specimens should be ground just before the strength test. (3) Every flatness of the end of the grounded specimen was within the limits regulated in JIS A 1132. (4) In this experiment, compressive strength decreased as the roughness of the end of the specimen increased. (5) In this experiment, the influence of the flatness on the strength reduction rate increased with the rise of the compressive strength level.
引用
收藏
页码：475 / 481
页数：6
相关论文
共 50 条
  • [1] Effect of Specimen Size and Shape on the Compressive Strength of High Strength Concrete
    Malaikah, Alaa S.
    PERTANIKA JOURNAL OF SCIENCE AND TECHNOLOGY, 2005, 13 (01): : 87 - 96
  • [2] Relation between Density and Compressive Strength of Foamed Concrete
    Othman, Rokiah
    Jaya, Ramadhansyah Putra
    Muthusamy, Khairunisa
    Sulaiman, MohdArif
    Duraisamy, Youventharan
    Abdullah, Mohd Mustafa Al Bakri
    Przybyl, Anna
    Sochacki, Wojciech
    Skrzypczak, Tomasz
    Vizureanu, Petrica
    Sandu, Andrei Victor
    MATERIALS, 2021, 14 (11)
  • [3] Specimen shape and size effect on the compressive strength of higher strength concrete
    Tokyay, M
    Ozdemir, M
    CEMENT AND CONCRETE RESEARCH, 1997, 27 (08) : 1281 - 1289
  • [4] Specimen Size and Shape Effect on the Compressive Strength of Normal Strength Concrete
    Gyurko, Zoltan
    Nemes, Rita
    PERIODICA POLYTECHNICA-CIVIL ENGINEERING, 2020, 64 (01): : 276 - 286
  • [5] Effect of specimen size and capping method on apparent compressive strength of high-strength concrete
    1600,
  • [6] Basic study grouted sand specimen preparation methods and compressive strength
    Matsui, S
    Nakazato, Y
    Tokoro, T
    Takahashi, N
    GROUTING AND DEEP MIXING, VOL 1, 1996, : 177 - 182
  • [7] Study on the relation between uniaxial compressive strength and point load strength
    Wang, Ruihong
    Jiang, Yuzhou
    Guo, Jinlong
    Tang, Tiancai
    ADVANCES IN CIVIL AND STRUCTURAL ENGINEERING III, PTS 1-4, 2014, 501-504 : 282 - +
  • [8] Effect of Specimen Shape and Size on Compressive Strength of Concrete
    Che, Yi
    Ban, Shenglong
    Cui, Jianyu
    Chen, Geng
    Song, Yupu
    ADVANCES IN STRUCTURES, PTS 1-5, 2011, 163-167 : 1375 - +
  • [9] Effect of specimen sizes on flexural compressive strength of concrete
    Kim, JK
    Yi, ST
    Kim, JHJ
    ACI STRUCTURAL JOURNAL, 2001, 98 (03) : 416 - 424
  • [10] EFFECTS OF SPECIMEN TYPE AND DIMENSIONS ON COMPRESSIVE STRENGTH OF CONCRETE
    Felekoglu, Burak
    Turkel, Selcuk
    GAZI UNIVERSITY JOURNAL OF SCIENCE, 2005, 18 (04): : 639 - 645
12345