Electromagnetic Interference Filter Design of Single-Phase Inverter Based on the Noise Source Impedance Extraction

被引:0
|
作者
Jiang S. [1 ]
Liu Y. [1 ]
Yin S. [2 ]
Peng J. [1 ]
机构
[1] College of Mechatronics and Control Engineering, Shenzhen University, Shenzhen
[2] Microsystem and Terahertz Research Center, China Academy of Engineering Physics, Chengdu
关键词
Common mode; Differential mode; Electromagnetic interference(EMI); EMI filter; Noise source impedance; Single-phase inverter;
D O I
10.19595/j.cnki.1000-6753.tces.181105
中图分类号
学科分类号
摘要
This paper studied a method of extracting the Electromagnetic interference (EMI) noise source impedance of a single-phase inverter. Based on this, an effective EMI filter design method was proposed. This approach allows accurate filter requirements analysis and design to take the effects of common mode (CM) and differential mode (DM) noise source impedances into account. In order to further improve the accuracy of noise source impedance detection and the effectiveness of filter design, this paper also used the RLC impedance analyzer to accurately analyze the impedance frequency characteristics of the test components. Finally, the feasibility and effectiveness of this method was tested in simulation and experiment based on a single-phase SiC MOSFET inverter. The results show that the EMI filter designed by the proposed method has strong pertinence and high reliability without time-consuming rectification. © 2019, Electrical Technology Press Co. Ltd. All right reserved.
引用
收藏
页码:3552 / 3562
页数:10
相关论文
共 26 条
  • [1] Li J., Ma H., Hui D., Present development condition and trends of energy storage technology in the integration of distributed renewable energy, Transactions of China Electrotechnical Society, 31, 14, pp. 1-10, (2016)
  • [2] Qu K., Li W., Ye T., Et al., State feedback based decoupling control strategy for grid-connected inverter with LCL filter, Transactions of China Electrotechnical Society, 31, 20, pp. 130-138, (2016)
  • [3] Hu C., Hu J., Chen Q., Et al., Suppression method of common-mode voltage for three-level active neutral-point-clamped inverter based on selective harmonics elimination PWM, Transactions of China Electrotechnical Society, 31, 16, pp. 93-102, (2016)
  • [4] Mao J., Fang J., Discussion on harmonic suppression and control design method of low voltage distribution system, Modern Architeeture Electric, 18, 1, pp. 29-34, (2018)
  • [5] Zhang Y., Ye S., Zhang J., Et al., Review of conducted noise suppression method for power electronic and electrical equipment, Transactions of China Electrotechnical Society, 32, 14, pp. 77-86, (2017)
  • [6] Ala G., Giaconia G.C., Giglia G., Et al., Design and performance evaluation of a high power density EMI filter for PWM inverter-fed induction motor drives, IEEE Transactions on Industry Applications, 52, 3, pp. 1573-1579, (2016)
  • [7] Akagi H., Shimizu T., Attenuation of conducted EMI emissions from an inverter-driven motor, IEEE Transactions on Power Electronics, 23, 1, pp. 282-290, (2008)
  • [8] Ala G., Piazza M.C.D., Ragusa A., Et al., EMI analysis in electrical drives under lightning surge conditions, IEEE Transactions on Electromagnetic Compatibility, 54, 4, pp. 850-859, (2012)
  • [9] Jiang Y., Xu D., Chen X., Et al., A novel PWM inverter output active filter for common-mode voltage cancellation, Proceedings of the CSEE, 22, 10, pp. 125-129, (2002)
  • [10] Zhang Y., Kuang G., Long L., Research of reduced common-mode voltage technique with nonzero vector pulse width modulation for three-phase inverters, Power System Protection and Control, 41, 2, pp. 138-143, (2013)