Influence of surface geometry and structure after non-conventional methods of parting on the following milling operations

被引：0
|
作者：
Mičietová, Anna [1 ]
Neslušan, Miroslav [1 ]
Čilliková, Mária [1 ]
机构：
[1] University of Žilina, Faculty of Mechanical Engineering, Department of Machining and Manufacturing Engineering, Univerzitná 1, 010 26, Slovakia
来源：
Manufacturing Technology | 2013年 / 13卷 / 02期
关键词：
D O I：
暂无
中图分类号：
学科分类号：
摘要：
引用
收藏
页码：199 / 204
相关论文
共 8 条
  • [1] Optimization of machining parameters for milling operations using non-conventional methods
    Baskar, N
    Asokan, P
    Prabhaharan, G
    Saravanan, R
    INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY, 2005, 25 (11-12): : 1078 - 1088
  • [2] Optimization of Machining Parameters for Milling Operations Using Non-conventional Methods
    N. Baskar
    P. Asokan
    G. Prabhaharan
    R. Saravanan
    The International Journal of Advanced Manufacturing Technology, 2005, 25 : 1078 - 1088
  • [3] Magnetic chuck failure prediction: towards the use of non-conventional clamping in milling operations
    Cantano, J.
    Alonso, J. M.
    Pelaez, G.
    Gago, I.
    Ulloa, A. F.
    Ares, J. E.
    MESIC MANUFACTURING ENGINEERING SOCIETY INTERNATIONAL CONFERENCE 2015, 2015, 132 : 419 - 426
  • [4] MgF2 as a non-conventional catalytic support.: Surface and structure characterization
    Wojciechowska, M
    Czajka, B
    Pietrowski, M
    Zielinski, M
    CATALYSIS LETTERS, 2000, 66 (03) : 147 - 153
  • [5] Analysis of surface integrity of parts after non conventional methods of machining
    Vajdová, alena
    Micietová, Anna
    Neslušan, Miroslav
    Kolarik, Kamil
    Manufacturing Technology, 2014, 14 (03): : 470 - 474
  • [6] SURFACE-ROUGHNESS OF TARNAMID PLASTIC AFTER MILLING - TESTS ON INFLUENCE OF CHOSEN MILLING PARAMETERS AND CUTTER GEOMETRY ON SURFACE-ROUGHNESS OF TARNAMID PLASTIC AFTER MACHINING
    KOSZKUL, J
    MECHANIK MIESIECZNIK NAUKOWO-TECHNICZNY, 1977, 50 (08): : 421 - 424
  • [7] Influence of cutting parameters on cycle time, surface roughness, dimensional error and cutting forces in milling operations on aluminium 6082 sculptured surface geometry
    Quintana G.
    Gómez X.
    Delgado J.
    Ciurana J.
    International Journal of Machining and Machinability of Materials, 2010, 8 (3-4) : 339 - 355
  • [8] Experimental assessment of roughness changes in the cutting surface and microhardness changes of the material S 355 J2 G3 after being cut by non-conventional technologies
    Mascenik, Jozef
    Gaspar, Stefan
    ADVANCED MANUFACTURING TECHNOLOGY, PTS 1-3, 2011, 314-316 : 1944 - 1947
1