Numerical simulation for microstructure control in wire arc additive manufacturing of thin-walled structures

The difference of cooling rates on the surface and the interior of thin-walled structures leads to significant differences of microstructures in additive manufacturing (AM). To reveal the microstructure control in wire arc additive manufacturing of thin-walled structures, a gas-heat coupling model with experimental validation is proposed. The computational accuracy can reach 96 % in prediction of temperatures and microstructures. Increasing the preheating or scanning speed leads to a higher probability of heterogeneous nucleation on the surface of thin-walled structures. When the pre-heating is increased from 550 K to 750 K, the proportion of equiaxed grains increases by 20.8 %. When the gas flow rate of super cooling is increased from 20 L/min to 30 L/ min, the size of equiaxed grains is decreased from 0.33 mm to 0.23 mm on the surface, and the width of columnar grains is decreased from 0.53 mm to 0.42 mm in the interior. This is due to the significant differences in cooling rates in thin-walled structures.