Effect of Znic on Microstructure and Mechanical Properties of Solid Solution Mg-Y-Nd-Zr Alloy

被引：0

作者：

Su Z. ^{[1
,2
,3
]}

Mo C. ^{[3
]}

Chen D. ^{[3
]}

Liang Q. ^{[2
]}

Chen Z. ^{[2
]}

机构：

[1] School of Mechatronic Engineering, Gongqing institute of Science and Technology, Jiujiang

[2] Guangdong Huihuang Metal Products Co.，Ltd., Zhaoqing

[3] Department of Mechanical and Energy Engineering, Shaoyang University, Shaoyang

来源：

Zhongguo Xitu Xuebao/Journal of the Chinese Rare Earth Society | 2024年 / 42卷 / 03期

关键词：

mechanical properties; Mg-Y-Nd-Zn-Zr alloy; microstructure; solid solution; strengthening mechanism;

D O I：

10.11785/S1000-4343.20240317

中图分类号：

学科分类号：

摘要：

Effects of Zn（0，0.5，1.0，1.5（%，mass fraction））on microstructure and mechanical properties of Mg-Y-Nd-Zr solid solution alloys were investigated by the optical microscopy（OM），scanning electron microsco‑ py（SEM），energy spectrometer（EDS）and X-ray diffractometry（XRD），including the mechanical properties test. It is obvious that Mg12Nd and Mg24Y5 phases in the solid solution alloy are dissolved into the matrix，while Mg12YZn phase exists at the grain boundary. With the increase of Zn content，the volume fraction of Mg12YZn phase increases gradually，the tensile strength，yield strength and elongation of the alloys increase first and then decrease. When Zn content is 0.5%，the tensile strength and yield strength of the solid solution alloy reach the maximum values，which are 252 and 158 MPa，respectively. When the Zn content increases to 1.0%，the maximum elongation of the alloy reaches 13.2%. The most significant factor contributing to the yield strength of the alloy is solid solution strengthening，which accounts for more than 54%. With the increase of Zn content，the volume fraction of Mg12YZn phase increases，which results in the solid solution strengthening decreasing，while the strengthening effect of the second phase slightly increases. © 2024 Editorial Office of Chinese Rare Earths. All rights reserved.

引用

页码：568 / 573

页数：5

共 19 条

[1] Chen Z Y, Li Q N, Chen X Y, Zhu H X., Research sta‑ tus and application of Zn-containing magnesium alloys and influence of LPSO on alloy properties［J］, Journal of the Chinese Society of Rare Earths, 39, 6, (2021)
[2] Ding Z B，, Zhang S，, Zhao Y H，, Chen D R，, Zou L H，, Chen Z G，, Su Z J，, Hou H., Effect of Al addition on mi‑ crostructure and mechanical properties of Mg-Gd-Zn al‑ loys［J］, Trans. Nonferrous Met. Soc. China, 32, 3, (2022)
[3] Zhang J H, Liu S J, Wu R Z，, Hou L G, Zhang M L., Recent developments in high-strength Mg-RE-based al‑ loys：Focusing on Mg-Gd and Mg-Y systems ［J］, J. Magnes. Alloy, 6, 3, (2018)
[4] Microstructure and mechani‑ cal properties of rolled and annealed Mg-Y-Zr-xNd al‑ loys［J］, Rare Metal Mat. Eng, 48, 7, (2019)
[5] The microstructure and mechanical properties of as-cast Mg-4Y/Nd-2Zn alloys［J］, Mater. Sci. Tech‑ nol, 6, 3, (2018)
[6] Fan W X，, Bai Y，, Li G Y，, Chang X Y，, Hao H., En‑ hanced mechanical properties and formability of hot-rolled Mg-Zn-Mn alloy by Ca and Sm alloying ［J］, Trans. Nonferrous Met. Soc. China, 32, 4, (2022)
[7] Zhang Q, Li Q A, Chen X Y, Chen Z., Effect of Sn addition on the deformation behavior and micro‑ structural evolution of Mg-Gd-Y-Zr alloy during hot com‑ pression［J］, Mater. Sci. Eng.，A, 826, (2021)
[8] Chen D J, Li Y J，, Zhang K，, Li X G., Study on phase constitutions，growth pattern and mechanical properties of Mg-1.4Gd-1.2Y-xZn-0.15Zr（at%）alloys［J］, J. Rare Earths, 38, 3, (2020)
[9] Zhang R, Huo Q H，, Xiao Z Y，, Zhang Y，, Hashimoto A，, Yang X L., Optimizing the mechanical properties of a Mg-Y-Nd-Zn-Zr alloy via interrupted compression with an intermediate annealing ［J］, Mater. Sci. Eng.，A, 812, (2021)
[10] Su Z J, Yang S Z, Liu C M, Yang X H, Liu X L., Ef‑ fect of Zn on microstructure and mechanical properties of as-cast Mg-Y-Nd-Zr alloy ［J］, Journal of Materials Engineering, 45, 9, (2017)

← 1 2 →