Experimental Research on Wind Resistance and Finite Element Analysis of Reinforced Concrete Composite Insulation Wall Plate

被引：0
|
作者：
Li Y. [1 ,2 ]
Guo W. [1 ]
Wang X. [1 ,2 ]
Miao Q. [1 ]
Huang Q. [3 ]
机构：
[1] School of Civil Engineering, Tianjin University, Tianjin
[2] Key Laboratory of Coast Civil Structure and Safety(Tianjin University), Ministry of Education, Tianjin
[3] School of Architecture, Tianjin University, Tianjin
来源：
Tianjin Daxue Xuebao (Ziran Kexue yu Gongcheng Jishu Ban)/Journal of Tianjin University Science and Technology | 2018年 / 51卷
关键词：
Fabricated composite plate; Finite element analysis; Load-deflection curve; Wind resistance;
D O I：
10.11784/tdxbz201804056
中图分类号：
学科分类号：
摘要：
The reinforced concrete composite insulation wall plate is a new kind of fabricated composite plate with the advantage of convenient construction, and meets the demand of steel structure Housing Industrialization. Through the bending bearing capacity test of 2 reinforced concrete composite insulation panels with connecting parts, the stress and deformation of the panels were obtained to investigate its working performance under the 100 m, 150 m and 200 m forward and inverted wind load. The reinforced concrete composite insulation wall plate was loaded until its load-bearing capacity was lost, and the bearing capacity of the wall plate with connecting parts under actual working conditions was investigated. The finite element software ABAQUS was used to simulate the experiments, and after comparison it was concluded that the simulation effect was good. It lays the foundation of parametric analysis and cracking load analysis. The result of experiment and finite element analysis shows that the wind resistance performance of the fabricated composite panel is outstanding. © 2018, Editorial Board of Journal of Tianjin University(Science and Technology). All right reserved.
引用
收藏
页码：95 / 102
页数：7
相关论文
共 14 条
  • [1] Ji W., A Study on Technology of Enclose Wallplate System in Steel Structure Residential Building, (2008)
  • [2] Ren H., The Experimental Study and Practicability Analysis of Hollow Shear Wall of Reinforced Concrete, (2005)
  • [3] Chen Z., Chen A., Brief introduction to "technology specification for design of steel structure dwelling houses in Tianjin, Steel Construction, (2004)
  • [4] Asteris P.G., Lateral stiffness of brick masonry infilledplane frames, Journal of Structural Engineering, 129, 8, pp. 1071-1079, (2003)
  • [5] Zhou N., The situation and foreground of prefabricated building, Architecture Engineering Technology and Design, 14, pp. 30-31, (2016)
  • [6] Chen Y., Discussion on development of China's residential industrialization from application of fabricated building structure system, Housing Science, 12, pp. 30-32, (2015)
  • [7] Jiang J., Sun L., Zhang Y., The Manual of Advanced Wall Materials, (2005)
  • [8] Qu X., Chen Z., Sun G., Experimental and numerical analysis study on the structural performance autoclaved aerated concrete(AAC)wall slab, Journal of Building Materials, 15, 2, pp. 268-273, (2012)
  • [9] Zhang G., Chen B., Xiao W., Et al., Research on flexural behavior of autoclaved aerated concrete external panel, Building Structure, 46, 13, pp. 97-102, (2016)
  • [10] Chen L., Experimental Investigation and Theoretical Analysis of Bond Properties and Bending Performance on Composite Panels of Ceramic Bamboo-Reinforced Concrete, (2012)
12