Research on the quality of large cubic gem diamond crystal

被引:0
|
作者
Chen, Kui [1 ]
Zhang, Li [1 ]
Zang, Chuan-Yi [2 ]
Zheng, Xi-Gui [1 ]
Zhu, Yong-Gang [1 ]
机构
[1] Department of Mechanical Engineering, Zhengzhou College of Science and Technology, Zhengzhou 450064, China
[2] School of Physics and Chemistry, Henan Polytechnic University, Jiaozuo 454000, China
关键词
Diamonds - Nitrogen - Crystal impurities;
D O I
暂无
中图分类号
学科分类号
摘要
In this paper, high quality hexahedron diamond crystals were grown via the temperature gradient under high pressure and high temperature (HPHT), which is between 1300°C and 1350°C. The crystals were grown based on the steady growth of the high quality big single crystal through rational adjusting the crystal bed high to 5 mm. The results show that the weight of the crystal is 2.04 carat in 30 h, and the growth rate by weight was achieved to 13.6 mg/h, which was far much higher than samples from Sumitomo Corporation of Japan and Element Six Corporation. The lattice crystallization degree was lower than the Sumitomo Corp. sample, but higher than that of the Element Six Corp. sample. The strong diamond Raman standard peak was appeared in the 1332 cm-1 place of our diamond samples by the Laser-Raman test, and the half tall wide value of the Raman peak is 5.570 cm-1 by the Gaussian simulation. The average nitrogen content of our diamond samples was 240 ppm of the {100} faces, which was much higher than the Sumitomo and Element Six samples, because of the existence of impurity in the test conditions.
引用
收藏
页码:620 / 624
相关论文
共 50 条
  • [1] Growth of high-quality large cubic gem diamond crystals
    Chen, Kui
    Zang, Chuan-Yi
    Chen, Li-Xue
    Chen, Xiao-Zhou
    Wu, Jie
    Wang, Jie
    Rengong Jingti Xuebao/Journal of Synthetic Crystals, 2010, 39 (02): : 324 - 327
  • [2] Frictional characteristics of diamond sliding on as-grown surfaces of large GEM quality single crystal synthetic diamond
    Lee, M
    Morris, WG
    Han, AK
    Kennedy, F
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 1996, 209 (1-2): : 60 - 67
  • [3] Design an Effective Solution for Commercial Production and Scientific Research on Gem-Quality, Large, Single-Crystal Diamond by High Pressure and High Temperature
    Han, Qi-Gang
    Liu, Bao
    Hu, Mei-hua
    Li, Zhan-chang
    Jia, Xiao-Peng
    Li, Ming-Zhe
    Ma, Hong-An
    Li, Shang-Sheng
    Xiao, Hong-Yu
    Li, Yong
    CRYSTAL GROWTH & DESIGN, 2011, 11 (04) : 1000 - 1005
  • [4] Characterization of high-quality large cubic diamond crystals
    School of Physics and Chemistry, Henan Polytechnic University, Jiaozuo 454000, China
    不详
    不详
    Rengong Jingti Xuebao, SUPPL. 1 (301-304+330):
  • [5] Growth and characterization of large, high quality cubic diamond crystals
    Zang ChuanYi
    Li Ming
    Chen LunJian
    CHINESE SCIENCE BULLETIN, 2012, 57 (14): : 1733 - 1738
  • [6] Growth and characterization of large,high quality cubic diamond crystals
    ZANG ChuanYi 1*
    2 Institute of Materials Science and Engineering
    Chinese Science Bulletin, 2012, 57 (14) : 1733 - 1738
  • [7] Modeling of effective design of high pressure anvils used for large scale commercial production of gem quality large single crystal diamond
    Han, Qi-Gang
    Li, Ming-Zhe
    Jia, Xiao-Peng
    Ma, Hong-An
    Li, Yuefen
    DIAMOND AND RELATED MATERIALS, 2011, 20 (07) : 969 - 973
  • [8] Dependence of crystal quality and β value on synthesis temperature in growing gem diamond crystals
    Xiao Hong-Yu
    Jia Xiao-Peng
    Zang Chuan-Yi
    Li Shang-Sheng
    Tian Yu
    Zhang Ya-Fei
    Huang Guo-Feng
    Li-Qiu
    Ma Hong-An
    CHINESE PHYSICS LETTERS, 2008, 25 (04) : 1469 - 1471
  • [9] Stress analysis of the multi-layer stagger-split die for synthesizing gem quality large single crystal diamond
    Zhao, Liang
    Li, Mingzhe
    Li, Rui
    Qu, Erhu
    Wang, Liyan
    Yi, Zhuo
    Zheng, Chengxiang
    DIAMOND AND RELATED MATERIALS, 2018, 83 : 54 - 59
  • [10] Largest gem-quality diamond unearthed
    不详
    CANADIAN MINING JOURNAL, 2008, 129 (06) : 6 - 6